Dimplex DXDH10N Installation And Operating Instructions Manual

SAFETY INFORMATION

1. Please read the operating instructions carefully before using your
dehumidifier for the first time and keep them in a safe place.

2. Never immerse the appliance in water or other liquids.

3. Never operate the appliance if a cable or connector has been damaged,
after appliance malfunction or if the appliance was dropped or otherwise
damaged.

4. Electric appliance may only be repaired by qualified personal, improper
repair work can be a source of considerable danger for the users.

5. Children are not aware of the hazards of electric appliance. Therefore,
never allow children to manipulate electric appliance unless properly
supervised.

6. Disconnect the appliance from mains power whenever it is not in use,
before relocating it, and before cleaning,

7. Operate the appliance only at the voltage specified on the type plate.

8. Use the appliance only in the household, and only for the purpose it was
designed for.

9. Do not place heavy objects on the appliance.

10. To prevent spillage, empty the water tank before relocating the
appliance.

11. Do not tip the appliance to any side as escaping water could damage the
appliance.

12. This appliance is not intended for use by persons (including children)
with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for
their safety. Children should be supervised to ensure that they do not
play with the appliance.

13. When the supply cord is damaged, it must be replaced by the
manufacturer, its service agent or similarly qualified persons in
order to avoid a hazard.

14. The devices should be installed at minimum distant of 50CM from
the wall or other obstacle.

15. Unplug the appliance before cleaning.

OPERATING INSTRUCTIONS

1. Control panel

2. Air outlet

3. Handle

4. Front panel

5. Back panel

6. Water outlet tube (continuous use)

7. Water tank

CONTROL PLATE DESCRIPTION

OPERATION INSTRUCTION

Starting the unit

1. Firstly, turn the humidity control switch to the “OFF” position.

2. Plug in the dehumidifier.

3. Turn on the humidity control switch(clockwise) and turn the same switch to

the reading of the desired humidity(60% in general as shown on position”4”).

Turning off the unit

1. Turn the humidity control switch fully anticlockwise to the “OFF” position and

the power supply is cut off and the unit stops operating.

2. If the dehumidifier is not in use for a long time, please disconnect the power

cord plug from the supply outlet.

NOTES AND PRECAUTIONS

1. The dehumidifier will not operate if the humidity setting is higher than the
ambient humidity.

2. When the water in the tank is full an automatic float switch shuts down the
product and the water level indicator light illuminates. Remove the water
storage tank and empty its contents, carefully replace the empty water tank
back in position, the unit will now automatically restart operating.

3. When the unit stops, you have to wait for 3 minutes before you can restart
the unit to protect the compressor from damage.

4. The following table indicates the approximate relative humidity setting
against its related position number on the humidity control switch:

CONTROL SWITCH

POSITION NO.

APPROXIMATE

HUMIDITY SETTING

8

20﹪

7

30﹪

6

40﹪

4

60﹪

2

80﹪

5. The operational temperature range for this unit is 5-35°C.

6. Other than on the case of note 2 above , where the dehumidifier does not

start, the operational light does not illuminate or the dehumidifier

intermittently stops for unknown reasons, please check the plug and power

supply for poor connection. If the plug and power supply are in good

condition, wait for 10 minutes and restart the unit (it can take about 10

minutes for the unit to reset). If the unit still does not start after 10 minutes,

please contact your retailer or the manufacturer for repair.

7. When the dehumidifier is in operation, the running compressor will

produce heat , this is normal , this may potentially raise the room

temperature.

DRAINAGE INSTRUCTION

The extracted water can be collected by water tank(set up as supplied), or can

be set up to drain continuously using a Fig 01

PVC hose (see details below, not included):

USE OF WATER TANK:

When the water full indicator illuminates, the tank is

full, and the compressor and the fan will stop

operation, please empty the water tank:

Remove the water tank as per Fig 01. and empty it.

Gently refit the water tank into the unit in its original position.

CONTINUOUS DRAINAGE

1. If you want to use this function, please pull out

the water tank and plug a 9mm internal diameter

water pipe onto the “Water out tube” (See

Fig.02). replace the water tank into the unit, the

unit will now operate while discharging the

extracted water through the free end of the fitted

pipe, (note, please ensure the free end is below the outlet connection).

Fig 02

Filter Removal

•To remove the filter you must first remove the water tank as instructed above.

•The filter can then be removed from its slot by gripping the filter handle and

sliding it down and out of the back of the appliance as indicated below.

• Every 2 weeks, remove the filter and clean

it with warm water, below 40°C. Allow it to

dry naturally and then replace by reversing

the removal instruction above.

Care and Maintenance Instruction

1. To avoid the occurrence of vibration and noise the unit should not

operated while located on any soft or uneven surface.

2. Never insert any foreign objects into the unit through its air inlet or outlet to

avoid hazard or unit failure.

3. During power off or when not in use for a long time, please disconnect the

product from the mains.

4. For a better dehumidifying effect, the areas in front and rear of the unit

should be clear and free from any obstacles which will block the air flow of

the unit.

5. Clean the filtering net once every two weeks (never use alcohol, gasoline

or hot water with a temperature greater than 40 degrees C.

SPECIFICATIONS

MODEL

SPECIFICATION

DXDH10N

POWER SUPPLY

1∮220-240V~50Hz

POWER INPUT 250W

RUNNING CURRENT 1.2A

NET WEIGHT 11.1Kg

MOISTURE REMOVAL

liter/day 30℃RH 80%）

10 litre/day

CABINETDIMEMSION (W)365x(D)220 x(H)490

TEMP. RAHGE FOR USE

5℃~35℃

WATER TANK CAPACITY 2.3L

(CE) N 842/2006:

R134A is a kind of fluorinated greenhouse gas covered by

the Kyoto Protocol.

Its total global warming potential (GWP) is 1300