Page 1
INSTRUCTION MANUAL
50cm HV Pedestal Fan
Model: DCPF50MB
For domestic household use only.
Page 2
IMPORTANT
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR
FUTURE REFERENCE. Note also the information presented on the appliance
CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE INJURY AND/
OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY
Please read the operating instructions carefully before using your fan for the rst time
and keep them in a safe place.
WARNING – This appliance must not be used in a bathroom.
WARNING – Do not use this appliance in the immediate surroundings of a bath, a
shower or a swimming pool.
• Never immerse the appliance in water or other liquids.
• Operate this unit only on a rm, at surface.
• Do not place on soft, unstable or non-horizontal/angled surfaces.
• Never operate the appliance if a cable or connector has been damaged, after
appliance malfunction or if the appliance was dropped or is otherwise damaged.
• If the mains lead is damaged it must only be replaced by the manufacturers service
agent or a similarly qualied person in order to avoid a hazard.
• Please ask a professional service agent to repair the product. Improper repair may
cause danger to users.
• Disconnect the appliance from mains power whenever it is not in use, before
relocating it, and before cleaning.
• Operate the appliance only at the voltage specied on the rating label.
• Only connect the unit to a properly installed and easily accessible socket so that
you can quickly disconnect the plug if necessary.
• Do not connect this product to the mains using an extension lead.
• This fan is only intended for INDOOR RESIDENTIAL applications. This fan should
not be used for commercial or industrial or leisure applications or in small enclosed
spaces.
• Never use the mains lead as a carrying strap or pulling lead.
• To avoid a re or electrocution hazard, NEVER put the cord near heat registers,
radiator, stoves or heaters.
• DO NOT cover cord with carpeting, throw rugs, runners, or similar coverings.
• DO NOT route cord under furniture or appliances. Take care to position the cord
away from trac areas and where it will not be a tripping hazard.
• DO NOT use the unit near windows or where water collects. Rain and water collection
may lead to a risk of re or electric shock.
• Only operate this appliance with a minimum of 50cm clearance all around i.e. away
from walls, furniture and overhanging objects such as curtains or a shelf.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning use
of the appliance by a person responsible for their safety.
2
Page 3
• Children should be supervised to ensure they do not play with the appliance.
• WARNING: To avoid danger of suocation please remove all packaging materials
particularly plastic and EPS and keep these away from vulnerable people, children
and babies.
• NEVER drop or insert any object or ngers into any openings.
• Do not use the appliance in locations where paint, petrol or other ammable liquids
are used or stored.
•
• Do not use bug sprays or other ammable cleansers/vapour sprays on or around
the unit.
• Always switch o the unit and take the plug out of the socket:
•
•
•
•
If you are not using the unit
Before you clean or carry out maintenance on the unit
If a fault occurs
In the event of an electrical storm.
• Avoid electromagnetic interference. Keep the unit at least 1 metre away from
electrical appliances such as televisions & radios.
3
Page 4
Exposed to the
weather outdoors
Near water If the power cable
wires are frayed or cut
Where small children
may be left unattended
On a slope or
uneven surface
If an extension
lead may become
overloaded
Where there is risk
of re or close to
a naked ame
Where the power
cable may be
damaged
Where it may be
damaged by
chemicals
Where there is a risk
of interference by
This product is not
made for DIY repair
foreign objects
4
If there is a risk
of water falling on
the unit
Page 5
Specication
Model no. DCPF50MB
Colour
Power supply
Rated power
Speed settings
Modes -
Timer -
Remote control -
Adjustable height Yes - Max height 1.5m
Tilt adjustable head Y
Horizontal oscillation Y
Noise level
Weight (net) 14kg
Dimensions (w x d x h) 580 x 380 x 1500mm
Matte Black
220-240V~, 50/60Hz
135W
3
73dB(A)
• For greater precision, please always refer to the rating label placed on the product.
Included:
• Fan
• 19mm bolt & washer
• 1 x long bolt & washer
• 4 x rear grille screws
• 1 x grub screw
• 1 x safety grill screw & bolt
5
Page 6
Parts
1. Front grille
16. Safety screw
2. Grub screw
4. Rear grille
screws
6. Motor shaft
7. Oscillation On/
O switch
8. Fan motor
9. Rotary switch
10. Motor xing hole
11. Adjustable pipe xing
hole & long bolt & washer.
5. Rear grille
3. Fan blade
Rotary switch speed settings (9)
12. Adjustable pipe
13. Pipe base cover
14. Base
15. 19mm bolt & washer
Oscillation On/O button (7)
6
Page 7
Assembly
1. Assemble the base (14) to the adjustable pipe (12) by holding the base on it's
side, and inserting the pipe into the centre. Secure the pipe (12) to the base (14)
with the supplied 19mm bolt & washer (15). Firmly tighten with a 19mm spanner
(not supplied).
2. To assemble the fan motor (8) to the adjustable pipe (12) locate the motor xing
hole (10) and align with the adjustable pipe xing hole (11). To secure the fan
motor to the adjustable pipe, use the long bolt & washer (supplied) and push
through the hole. Tighten the bolt well.
3. Align the rear grille (5) to motor shaft (6) on the fan motor (8) and ensure the
hole for the safety screw is at the bottom. The 4 screw holes on the front of the
fan motor (8) should line up. Firmly tighten all four rear grille screws (4).
4. Once the rear grille (5) is attached to the fan motor (8), turn the motor shaft
(6) so the at area is at the top. Slide the fan blade (3) all the way onto the
motor shaft (6) and rmly tighten the grub screw (2) by rotating in a clockwise
direction.
5. Once the fan blade is xed, align the top locking clip on the front grille (1) so it
xes to the that of the rear grille (5). Lock the side and bottom clips in place.
TIP: the logo should be horizontal. Secure the front & rear grille, by inserting and
xing the safety screw (16) and nut.
Operation
1. Ensure the rotary switch (9) is in the '0' position, prior to connecting the plug to
the power supply.
2. Switch the fan ON by rotating the rotary switch (9) on the back of the fan motor
(8) to the desired setting - 1, 2 or 3. Turn to the '0' position to turn OFF.
3. To start oscillation, press the oscillation On/O switch (7) to the 'I' position. To
turn oscillation o, press to 'O' position.
4. The airow direction can be adjusted upward/downward by lifting up or pressing
down the motor housing.
NOTE: Only adjust the fan head when the unit is OFF. Be careful not to insert your
ngers through the guard.
7
Page 8
Cleaning
Over time, dust can accumulate on the front & rear grille cover and fan blades, which
can aect the fans performance. It is recommended to clean the fan at least once a
month.
1. Turn the unit OFF and disconnect the appliance from the power supply.
2. Remove any dust build up with a soft brush.
3. Wipe the surface of the unit with a soft damp cloth. Mild detergent can be used
for any stubborn marks.
Do not use abrasive sponges, scouring pads, or a sti brush to clean the
IMPORTANT
The control panel and other parts must not come into contact with water or any
other liquids.
Storage
If not using the unit for an extended period of time. After cleaning please:
• Turn the unit o, unplug and take care of the mains lead & plug.
•
Cover the unit and store it upright in a location where it will not receive direct sunlight.
NB- Prolonged exposure to direct sunlight will discolour the enclosure.
8
Page 9
Maintenance
If the unit fails to operate eciently, is broken or other problems arise, unplug and
do not operate. Ask for advice by calling your local after sales service agent or the
Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ).
Warranty
Please refer to the warranty card in the box for warranty information. For any
troubleshooting advice, please contact the relative Customer Care Centre below.
Glen Dimplex Australia Pty Ltd Glen Dimplex New Zealand Ltd
1340 Ferntree Gully Road, 38 Harris Road, East Tamaki,
Scoresby 3179, Victoria Auckland 2013
Australia New Zealand
Ph: 1300 556 816 Ph: 0800 666 2824
Recycling: Do not dispose of electrical appliances as unsorted
municipal waste. Use separate collection facilities. Contact your
local government for information regarding the collection systems
available. If electrical appliances are disposed of in landlls or dumps,
hazardous substances can leak into the ground water, polluting the
food chain and damaging health and well-being.
9
Page 10
Customer Care: 1300 556 816
customer.care@glendimplex.com.au
www.dimplex.com.au
Supplied by Glen Dimplex Australia
1340 Ferntree Gully Road, Scoresby, Victoria, 3179
© Glen Dimplex Australia. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without
prior permission in writing of Glen Dimplex Australia.
10
Loading...