Dimplex DCPF40 User Manual

40cm HV PEDESTAL FAN

Model: DCPF40

INSTRUCTION MANUAL

PLEASE READ THE INSTRUCTION MANUAL CAREFULLY BEFORE USING THE UNIT

TABLE OF CONTENTS

IMPORTANT INFORMATION..……………………………………………………… 1
STRUCTURE….……………….…………………………………………………………. 3
ASSEMBLY & OPERATION…………………….…………………………………….. 4
CLEANING & MAINTENANCE..…………………………………………………….. 5
TECHNICAL SPECIFICATIONS.….…………………………………………………. 7

WARRANTY.............…..………..……………………………………………………. 7

2

IMPORTANT INFORMATION

Warnings

 Never place the unit near any gas appliances, f ire or flammable

liquids.

 Never hit or shake the unit to prevent damage.
 Never cover or obstruct the air inlet or outlet to p revent overheating.
 Never spray water or place the unit near water to prevent electric

shock.

 Only ever have a professional technician, manufacturer or a service

agent to replace a damaged power cord.

 Never share the power outlet with other appliances.
 Never connect or disconnect the power plug with wet hands to avoid

electric shocks.

 Never put rods or objects into the opening of the unit.
 Never use an extension cord with this unit.

Cautions

 Be sure the unit is placed on a stable surface when operating to

avoid overturning.

 The unit must not be used if the guards are not fastened according

to instructions.

 This appliance is for indoor use only.
 Do not plug the unit into a power socket before assembly is

complete.

 Never insert fingers, pencils, o r any other object through the guard

when unit is running.

1

 Power plug must be removed fr om the power socket before

cleaning, servicing, maintenance or moving from one location to
another.

 The unit should not be placed in a damp place or where humidity is

high (such as a bathroom).

 Electrical connections shall be in accordance with National or Local

Codes.

 Keep the unit at least 1 metre away from electric appliances such as

TV’s and radios, to avoid electromagnetic interference.

 Do not expose the unit under direct sunlight to avoid surface colour

fading.

 Do not tilt the unit more than 35 degrees or upside down while

transporting.

 Place the unit on a flat surface with less than 5 degree inclination.
 To avoid damaging the unit, do not use chemical solvents (i.e.

Benzene, alcohol-grazer) or harsh cleaners when cleaning the unit.

 Do not use your appliance with an extension cord unless it has been

checked and tested by a qualified electrician or electrical supplier.

 This appliance is not intended for use by persons (including children)

with reduced physical, sensory or mental capabilities, or lack of
experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person
responsible for their safety.

 Children should be supervised to ensure that they do not play with

the appliance.

2

STRUCTURE

1. Screw

2. Front guard

3. Blade

4. Position screw

5. Rear guard

6. Nut

7. Set screw

8. Power switch

9. Oscillation knob

10. Motor

11. Power cord

12. Tube

13. Cover ring

14. Joint screw

15. Spring washer

16. Spring

17. Base plate

18. Spring washer

19. Rubber washer

20. Nut

3

ASSEMBLY & OPERATION

If your fan comes ready assembled ignore this section.

Assembly of your pedestal fan

1. Separate the front and rear guard if they are connected.

2. Remove the four position screws on the motor, offer up and align
the rear guard with the four holes on the motor (handle to top of the
fan) insert the four position screws and tighten.

3. Loosen the set screw on the blade, slide the blade into the shaft of
the motor, and tighten the set screw ont o the flat of the shaft to
secure the blade. Ensure that the blade does not foul the guards.

4. Assemble the front guard to the rear guard. Tighten the screw and
nut, and secure the retaining slip s.

5. Loosen the set screws on the base plate with the spanner provided.
Attach the pole and re-tighten the screws back onto the base plate.

Operation of your pedestal fan

The power switch is incorporated in the speed control switch on top of the
fan.
0 – The fan is switched off.
1 – The fan operates at the lowest speed.
2 – The fan operates at medium sp eed.
3 – The fan operates at the highest speed.

To blow air in one direction and stop oscillation, allow the fan to move into
the desired position and pull the clutch knob u p. Press the clutch knob down
to return to a normal oscillation function.

4

CLEANING AND MAINTENANCE

Cleaning

1. Always unplug the fan before cleaning.

2. To clean the blade and grille assembly, first remove the safety grille,
unscrew the locknut and remove the blade from the unit.

3. Clean the unit with a soft cloth moistened with a mild soa p solution.
Use dry cloth to wipe the fan after cleaning.

4. Never use strong or volatile chemicals to clean the unit as it will
damage the plastic parts.

5. Do not immerse in water for cleaning, never allow water to drip into
the motor housing.

6. In the off-season, it is important to keep your unit in a safe, dry
location. Please remember to protect th e unit from dust or moisture.

Meaning of crossed-out wheeled dustbin

1. Do not dispose of electrical appliances as unsorted municipal waste,
use separate collection facilities.

2. Contact your local government for information regarding the
collection systems available.

3. If electrical appliances are disposed of in landfills or dumps,
hazardous substances can leak into the groundwater and get into

the food chain, damaging your health and
well-being.

5

Maintenance

If the unit working efficiency decreases, the unit is broken or other problems
arise, please stop running the unit and unplug it. Ask for advice by calling
your local after sales service agent or the Customer Care Centre on 1300 556
816 (AU) / [phone] (NZ)

1

6

TECHNICAL REFERENCE DATA

g

Model DCPF40

Rated Power 50W
Voltage/Frequency 220V-240V/50Hz
Net Weight 9.2k
Dimensions
HxWxD

N16269

Warranty:

The warranty is valid for 12 months from date of purchase. For service
advice, please contact the Customer Care Centre on 1300 556 816 (AU) /
[phone] (NZ)

Body (mm) (1100-1350)X403x450
Package (mm) 610X475x170

Glen Dimplex Australia Pty Ltd Glen Dimplex Australasia Ltd

Unit 1, 21 Lionel Road, 38 Harris Road, East Tamaki,
Mount Waverley VIC 3149 Manukau, Auckland 2013
Australia New Zealand
Ph: 1300 556 816 Ph: [phone]
Fax: [phone] Fax: [phone]
Web: www.dimplex.com.au Web: www.dimplex.co.nz

0

7