INSTRUCTION MANUAL
Air Circulator Pedestal Fan
Model: DCACP30DC
For domestic household use only.
IMPORTANT
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND
RETAINED FOR FUTURE REFERENCE.
Note also the information presented on the appliance
CAUTION: FAILURE TO FOLLOW THESE INSTRUCTIONS MAY CAUSE
INJURY AND/OR DAMAGE AND MAY INVALIDATE YOUR WARRANTY
Please read the operating instructions carefully before using your air circulator
for the rst time and keep them in a safe place.
WARNING – This appliance must not be used in a bathroom.
WARNING – Do not use this appliance in the immediate surroundings of a bath,
a shower or a swimming pool.
• If the mains lead is damaged it must only be replaced by the manufacturers
service agent or a similarly qualied person in order to avoid a hazard.
• This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
• Children should be supervised to ensure they do not play with the appliance.
• Prior to cleaning or other maintenance, the appliance must be disconnected
from the supply mains.
• Never immerse the appliance in water or other liquids.
• Do not place on soft, unstable or non-horizontal/angled surfaces.
• Never operate the appliance if a cable or connector has been damaged,
after appliance malfunction or if the appliance was dropped or is otherwise
damaged.
• If the mains lead is damaged it must only be replaced by the manufacturers
service agent or a similarly qualied person in order to avoid a hazard.
• Please ask a professional service agent to repair the product. Improper repair
may cause danger to users.
• Disconnect the appliance from mains power whenever it is not in use, before
relocating it, and before cleaning.
• Operate the appliance only at the voltage specied on the rating label.
• Only connect the unit to a properly installed and easily accessible socket so
that you can quickly disconnect the plug if necessary.
• Do not connect this product to the mains using an extension lead.
• This air circulator is only intended for INDOOR RESIDENTIAL applications.
This air circulator should not be used for commercial or industrial or leisure
applications or in small enclosed spaces.
• Never use the mains lead as a carrying strap or pulling lead.
• To avoid a re or electrocution hazard, NEVER put the cord near heat registers,
radiator, stoves or heaters.
2
• DO NOT cover cord with carpeting, throw rugs, runners, or similar coverings.
• DO NOT route cord under furniture or appliances. Take care to position the
cord away from trac areas and where it will not be a tripping hazard.
• DO NOT use the unit near windows or where water collects. Rain and water
collection may lead to a risk of re or electric shock.
• DO NOT COVER.
• Only operate this appliance with a minimum of 50cm clearance all around
i.e. away from walls, furniture and overhanging objects such as curtains or a
shelf.
• WARNING: To avoid danger of suocation please remove all packaging
materials particularly plastic and EPS and keep these away from vulnerable
people, children and babies.
• NEVER drop or insert any object or ngers into any openings.
• Do not use the appliance in locations where paint, petrol or other ammable
liquids are used or stored.
• Do not use bug sprays or other ammable cleansers/vapour sprays on or
around the unit.
• Always switch o the unit and take the plug out of the socket:
•
•
•
•
If you are not using the unit
Before you clean or carry out maintenance on the unit
If a fault occurs
In the event of an electrical storm.
• Avoid electromagnetic interference. Keep the unit at least 1 metre away from
electrical appliances such as televisions & radios.
WARNING - KEEP BATTERIES OUT OF REACH OF CHILDREN
• Swallowing may lead to serious injury in as little as 2 hours or death, due to
chemical burns and potential perforation of the oesophagus.
• If you suspect your child has swallowed or inserted a button battery immediately
call the 24-hour Poisons Information Centre on 13 11 26 (in Australia) or 0800
764 766 (in New Zealand) for fast, expert advice.
• Examine devices and make sure the battery compartment is correctly secured,
e.g. that the screw or other mechanical fastener is tightened. Do not use if the
compartment is not secure.
• Dispose of used button batteries immediately and safely. Flat batteries can
still be dangerous.
3
Exposed to the
weather outdoors
Near water If the power cable
wires are frayed or cut
Where small children
may be left unattended
On a slope or
uneven surface
If an extension
lead may become
overloaded
Where there is risk
of re or close to
a naked ame
Where the power
cable may be
damaged
Where it may be
damaged by
chemicals
Where there is a risk
of interference by
This product is not
made for DIY repair
foreign objects
4
If there is a risk
of water falling on
the unit
Specication
Model no. DCACP30DC
Power supply
Rated power
Speed settings
Modes 3
Timer 12 hours
Air movement 25m³/min
Air speed 7.5m/s
Up / Down oscillation 80 degrees
Left / Right oscillation 80 degrees
Noise level (MAX)
Weight (net) 3.4kg
Dimensions (w x d x h) 320 x 360 x 718-854mm
220-240V~, 50Hz
35W
30
55dB(A)
• For greater precision, please always refer to the rating label placed on the product.
5
How It Works
In contrast to a traditional fan which brings only cooling benets when directly facing
you; an air circulator works for any season, keeping the air in motion and making the
entire room more comfortable to be in.
Most fans simply lack the aerodynamics to keep the air in the room in motion. As
opposed to blowing air directly in contact with it, our Dimplex air circulators create a
3D oscillating draught in the form of an invisible jet stream.
This jet stream helps maintain a constant room temperature by ridding the room of
cold and warm spots. It also clears stuy atmospheres by circulating stale air with fresh
air from an open window.
Air circulators are the safe, all-year-round temperature regulation solution you’ve been
looking for.
Where To Position
During Summer, pointing the air circulator towards a wall halfway between the oor and
the ceiling, as well as using the highest setting, will set up a high speed air circulation
pattern.
This will cool down the room in an ecient manner. Pointing towards your air conditioner
will help distribute the cool air faster, saving time and energy; essentially Turbo boosting
your A/C.
During Winter, the use of a heater alone produces warm air that rises naturally to the
ceiling.
By pointing the air circulator upwards, and utilising the lowest speed setting, the hot air
will circulate with the cooler air near the oor, resulting in a more even room temperature.
6
Parts
Front grille
Brand badge
Base
Remote receiver
Remote Control
Dial
Rear grille
Extension button
Remote Control
Storage
7
Control Panel & LED Display
LED Display
Timer
Up/Down
Oscillation
Left/Right
Oscillation
Remote Control
Fan Speed
Set Timer
Natural Mode
Sleep Mode
On/O
Dial
On/O button
Timer increase/
decrease button
Left/Right
oscillation button
8
Mode button
Fan speed increase /
decrease button
Up/Down
oscillation button
Operation
ON/OFF
When in standby mode, press the On/O button on either the control panel or
remote control to turn the unit ON. The On/O & fan speed indicator lights will
illuminate, and the LED Display will show the current fan speed. To turn the unit OFF,
press the On/O button again.
FAN SPEED - DIAL
When the unit is ON, rotate the dial clockwise to increase the FAN SPEED. The fan
speed setting will indicate on the LED display - a number between 1-30. 30 is the
highest speed. Rotate the dial anticlockwise to decrease the FAN SPEED.
FAN SPEED - REMOTE CONTROL
Alternatively, when the unit is ON, press the FAN SPEED increase or decrease
buttons to set the desired fan speed. The selected speed will still show on the LED
Display.
NATURAL MODE
Press this button (or the MODE button on the remote) to activate the NATURAL
MODE. The NATURAL MODE indicator light will illuminate on the control panel once
selected. When the unit is in this mode, it automatically cycles through the speeds in
pre-set intervals. The 30 speeds are divided into 3 groups. Speeds 1-10 are group 1,
speeds 11-20 are group 2, and speeds 21-30 are group 3. Refer to below:
• Group 1 (Speeds 1-10): Low Natural Breeze Mode
• Group 2 (Speeds 11-20): Middle Natural Breeze Mode
• Group 3 (Speeds 21-30): High Natural Breeze Mode
NOTE: The LED display will only show speeds 10/20/30, depending on the group
selected.
To exit NATURAL MODE, press the button again.
SLEEP MODE
Press this button (or the MODE button on the remote) to activate the SLEEP MODE.
The SLEEP MODE indicator light will illuminate on the control panel once selected.
There are 3 x dierent sleep settings depending on the FAN SPEED. Refer to below:
• High Sleeping Mode: 30 minutes High Speed + Natural Mode > 30 minutes
Middle Speed + Natural Mode > Low Speed+ Natural Mode.
• Middle Sleeping Mode: 30 minutes Middle Speed + Natural Mode > Low Speed+
Natural Mode
• Low Sleeping Mode: Low Natural Mode.
To exit SLEEP MODE, press the button again.
9
Operation
TIMER - CONTROL PANEL:
The TIMER can be set to automatically turn the unit ON or OFF - up to a maximum
of 12 hours.
To automatically power ON:
1. Press the TIMER button on the control panel and the TIMER set indicator light
will illuminate. The LED Display will ash and start at 1 hour.
2. Turn the dial until the desired time from 1 to 12 hours displays on the LED.
After 5 seconds the LED Display will show the time set for the fan to turn ON
automatically.
3. To re-adjust the timer setting, press the TIMER button once and repeat the above
procedure. Alternatively, to cancel the TIMER, press one more time or set to '0'
hour.
To automatically power OFF:
1. Press the TIMER button on the control panel and the TIMER set indicator light
will illuminate. The LED Display will ash and start at 1 hour.
2. Turn the dial until the desired time from 1 to 12 hours displays on the LED.
After 5 seconds the LED Display will show the time set for the fan to turn OFF
automatically.
3. To re-adjust the timer setting, press the TIMER button once and repeat the above
procedure. Alternatively, to cancel the TIMER, press one more time or set to '0'
hour.
TIMER - REMOTE CONTROL:
Follow the same procedure above, however use the remote control and press the
timer increase & decrease buttons instead of using the dial on the control panel.
10
Operation
LEFT / RIGHT OSCILLATION
• When the unit is ON press the LEFT/RIGHT button on either the control panel or
remote control to begin oscillation. The LED indicator will illuminate accordingly
and the unit will begin to move left to right within 80°.
NOTE: When the fan is rst plugged in, it will oscillate 30° to calibrate the setting.
(left at 30° with a 9 second pause, followed by turning right to 80° and pausing for
15 seconds). If for some reason the oscillation angle is less than 30° or 80° then the
fan needs to complete the above process, so it can work normally.
• Press the LEFT/RIGHT button again to cancel the oscillation function.
UP / DOWN OSCILLATION
When the unit is ON press the UP/DOWN button on either the control panel or
remote control to begin oscillation. The LED indicator will illuminate accordingly and
the unit will begin to move Up and Down within 80°.
NOTE: Both LEFT/RIGHT & UP/DOWN oscillation directions can be used at the
same time. This will activate a 3D-like oscillation movement.
11
Cleaning
｀
Over time, dust can accumulate on the grille covers and fan blades, which can aect
the fans performance. It is recommended to clean the fan at least once a month.
1. Turn the unit OFF and disconnect the appliance from the power supply.
2. Remove any dust build up with a soft brush.
3. To clean the fan blades, remove the screw positioned at the front of the grille
and turn the front grille counterclockwise. Remove the screw nut from the motor
shaft and pull out the fan blade (refer to diagrams below).
4. Once the fan blade is clean, reassemble by following the instructions in reverse.
5. Wipe the surface of the unit with a soft damp cloth. Mild detergent can be used
for any stubborn marks.
IMPORTANT
The control panel and other parts must not come into contact with water or any
other liquids.
Storage
If not using the unit for an extended period of time. After cleaning please:
• Turn the unit o, unplug and take care of the mains lead & plug.
•
Cover the unit and store it upright in a location where it will not receive direct
sunlight. NB- Prolonged exposure to direct sunlight will discolour the outer casing.
CLEANING THE FAN BLADE
1. Remove the screw
2. Rotate the front grill counter-clockwise
3. Remove the screw nut
and pull out the fan blade
12
Maintenance
If the unit fails to operate eciently, is broken or other problems arise, unplug and
do not operate. Ask for advice by calling your local after sales service agent or the
Customer Care Centre on 1300 556 816 (AU) / 0800 666 2824 (NZ).
Warranty
Please refer to the warranty card in the box for warranty information. For any
troubleshooting advice, please contact the relative Customer Care Centre below.
Glen Dimplex Australia Pty Ltd Glen Dimplex New Zealand Ltd
1340 Ferntree Gully Road, 38 Harris Road, East Tamaki,
Scoresby 3179, Victoria Auckland 2013
Australia New Zealand
Ph: 1300 556 816 Ph: 0800 666 2824
Recycling: Do not dispose of electrical appliances as unsorted
municipal waste. Use separate collection facilities. Contact your
local government for information regarding the collection systems
available. If electrical appliances are disposed of in landlls or dumps,
hazardous substances can leak into the ground water, polluting the
food chain and damaging health and well-being.
13
14
Customer Care: 1300 556 816
customer.care@glendimplex.com.au
www.dimplex.com.au
Supplied by Glen Dimplex Australia
1340 Ferntree Gully Road, Scoresby, Victoria, 3179
© Glen Dimplex Australia. All rights reserved. Material contained in this publication may not be reproduced in whole or in part, without
prior permission in writing of Glen Dimplex Australia.
15
Loading...