Dimplex CXD2000H, CXD2000V Installation Instructions
Dimplex CXD Ceramic Radiant Heaters
Model(s) : CXD2000H & CXD2000V
08/19367/0 Issue 8
THESE INSTRUCTIONS SHOULD BE READ CAREFULLY AND RETAINED FOR FUTURE REFERENCE
(IPX4)
IMPORTANT SAFETY ADVICE
Because the Dimplex Ceramic Radiant
Heater contains no moving parts
little maintenance is required. Before
undertaking any maintenance work on the
heater due attention must be paid to the
following:
This heater is designed to be horizontally
wall mounted only, it must not be ceiling
mounted.
Always ensure a safe mounting height, at or
above a minimum height of 1.8 metres from
ground level, so that the heater can not be
touched when in operation.
The heater must be wall mounted level ± 5º
to the horizontal.
Do not locate the heater immediately
above or below a fi xed socket outlet or
connection box.
WARNING:
Do not use this heater in the immediate
surroundings of a bath, a shower or a
swimming pool.
This appliance can be used by children
aged from 8 years and above and
persons with reduced physical, sensory or
mental capabilities or lack of experience
or knowledge if they have been given
supervision or instruction concerning the
use of the appliance in a safe way and
understand the hazards involved. Children
shall not play with the appliance. Cleaning
and user maintenance shall not be made by
children without supervision.
the hazards involved. Children aged from 3
years and less than 8 years shall not plug in,
regulate and clean the appliance or perform
user maintenance.
CAUTION:
Some parts of this product can become
very hot and cause burns. Particular
attention has to be given where children
and vulnerable people are present.
Always disconnect the heater from the
electricity supply before attempting to
work on or near it.
Always ensure a safe means of access using
an access tower or properly supported
ladder.
Do not cover the heater.
Keep combustible materials away from the
heater.
Do not position patio furniture, sunshades,
awnings and other combustible materials
too close to the heater.
Do not use heater if the elements are
broken - as injury may occur.
Allow adequate time (minimum of 30
mins.) for the elements and body casing
to cool before attempting to work on the
heater .
Wiring between the heater and the spur
outlet or isolation switch must be in a heat
resisting cable (e.g. polychloroprene).
NOTE:
Provide su cient slack to the cable to
allow for angular adjustment of the body.
Children of less than 3 years should be
kept away unless continuously supervised.
Children aged from 3 years and less than 8
years shall only switch on/o the appliance
provided that it has been placed or installed
in its intended normal operating position
and they have been given supervision
or instruction concerning the use of the
appliance in a safe way and understand
The supply cord should be regularly
examined for signs of damage and the
appliance is not to be used if the cord is
damaged.
The supply circuit to the heater must
incorporate a double pole isolating switch
having a contact separation of at least
3mm in all poles.
1.8m Min
Height
Heated Zone
45°
2.0m
Recommended
Mounting
Height
442
302
380
121442
380
500 Min
500 Min
Plan View
Side View
Front View
CXD2000V
121
Wall
1.8m Min
Height
Heated Zone
45°
2.0m
Recommended
Mounting
Height
442
302
380
121442
380
500 Min
500 Min
Plan View
Side View
Front View
CXD2000V
121
Wall
1.8m Min
Height
Heated Zone
45°
2.0m
Recommended
Mounting
Height
735
260
248
248
735
260
500 Min
500 Min
Plan View
Side View
Front View
121
Wall
442
302
380
121442
380
500 Min
500 Min
Plan View
Side View
Front View
121
Wall
1.8m Min
Height
Heated Zone
2.0m
Recommended
Mounting
Height
735
260
248
248
735
260
500 Min
500 Min
Plan View
Side View
Front View
121
Wall
Fig. 1
CXD2000V
CXD2000H
Fig. 2 Fig. 3
1
2
1
Fig. 4
E
D
C
B
A
Loading...