Dimplex DFB4047, 23"" Compact Parts And Service Manual

PARTS AND SERVICE MANUAL

FOR

COMPACT FIREPLACE

Model DFB4047

TABLE OF CONTENTS

OPERATION PAGE 1
PARTS DRAWING PAGE 3
PARTS LIST PAGE 4
LIGHT BULB REPLACEMENT PAGE 5
HEATER ON/OFF SWITCH REPLACEMENT PAGE 6
THERMOSTAT CONTROL REPLACEMENT PAGE 7
FLAME MOTOR/FLAME ROD REPLACEMENT PAGE 8
HEATER ASSEMBLY REPLACEMENT PAGE 9
CIRCUIT BOARD REPLACEMENT PAGE 10
POWER CORD REPLACEMENT PAGE 11
TERMINAL BLOCK/CAPACITOR REPLACEMENT PAGE 12

1

BATTERY

DFB4047

OPERATION

The fireplace is supplied with an integrated on/off remote control.

Note: Ensure that the fireplace 3 position switch is set to
the remote control setting.

To operate, push the ON button to turn fireplace on, push the

OFF button to turn the fireplace off.
BATTERY REPLACEMENT

To replace the battery, slide battery cover open on the hand
held transmitter.
Correctly install one 12 volt (A23) battery in the battery holder.

Close the batter cover.

Resetting the temperature cutoff switch

The heater is protected with a safety device to prevent overheating. Should the heater
overheat, an automatic cut out will turn the heater off and it will not come back on without
being reset. It can be reset by switching the ON/OFF SWITCH to OFF and waiting 5
minutes before switching the unit back on.

Caution

If you need to continuously reset the heater, unplug the unit and call your local dealer.

ON OFF

COVER

2

Three position ON/OFF switch

The switch has two ON positions marked with “-“ and “=”.
The “-“ position is for manual operation.
In this position the built-in remote control is bypassed.
The “=” position is for operating the unit with the provided remote control.
When in “=” position the unit is operated with the ON and OFF buttons of the remote
control.

When the switch is in the center position the unit is off.

Heat switch

The HEAT ON/OFF SWITCH supplies power to the heater fan and the heater element.
When the switch is in the ON position the heater operates if the thermostat calls for heat.

Heater thermostat control

To adjust the temperature to your individual requirements, turn the thermostat control
clockwise all the way to turn on the heater. When the room reaches the desired
temperature, turn the thermostat knob counter clockwise until you hear a click. Leave in
this position to maintain the room temperature at this setting. For additional heat, turn
clockwise until you hear the click again and the heater will turn on.

MAIN THREE
POSITION
ON/OFF

MANUAL
OPERATION

HEAT
SWITCH

OFF

REMOTE
CONTROL

THERMOSTAT

3

DFB4047

4

13

14

11

16

15

4

3

12

1

10

8

9

2

7

16

6

5