Triad II Specifications
General
ShapeRectan
Capacit
Seatin
Shell Material Ultralife™ / Granitex™ / Gelo
Dimensions 83½" x 66½" x 30½" H /
Corner Radii 16" (41 cm
Water Capacit
Dry Weight 640 lbs (291 k
Shipping Weight Domestic 640 lbs (291 kg) - Export 690 lbs (313 k
Full Weight 2310 lbs (1048 k
Skirt Material Domestic Synthetic - Export Wood or Synthetic
Pol
Floor Yes
Water System
Water Treatment S
Plumbin
Filters/Covera
Gate Valves 2
VCR Jet® - Air Ad
VCR Jet® - Rotator 7
VCR Jet® - Dual Rotator 0
VCR Jet® - Multi Port S
VCR Jet® - Mini Rotator 2
VCR Jet® - Mini Directional 6
VCR Jet® - Euro Directional 0
VCR Jet® - Euro Rotator 0
VCR Jet® - Mini Directional in NFJ 4
T
hoon Jet 0
Ozone Jet 1
Heater Return Jet 1
Pum
Returns 2
Diverter Valves 0
Floor Drains 1
Skimmer 8” Weir
Special Features
D
namic Massage Sequencer w/ control panel
NeckFlex® Jet Pillows 1
Headrest Pillows 2
Stereo s
Water Feature n/a
Water Feature Volume control n/a
Cu
Tactile Thera
Pump Information Domestic
Motor Size – Peak (Continuous) HP 4.0 (2.5) H
Jet Pum
Circulation
Fountain
Electrical S
Voltage 240 240
Am
Heater FastFlo 2.7
Thermostat Electronic Electronic
Li
Control S
U
Auxiliar
stem Optional Advanced In.Tune
Holders 2
s # of Pumps/Speed One / Dual One / single
erage 40/30 1X16 / 2X16 / 1X32
ht 1 with optional LED Multi color LED
stem MSPA-MP-D17 MSPA-MP-CE-D17
er Control (programable
stem Ultra Pure™
stems 1
e 2 / 75 sq. ft.
ustable/Directional 4
inner 0
stem Domestic
er Control No No
200 Gallons (757 Liters
M-Drive with Scrolling Message Center M-Drive with Scrolling Message Center
ular
3
®
212cm X 169cm x 77cm H
Yes
Foot & hand
60Hz
11
n/a n/a
60Hz
4.0,5.5 kW FastFlo 2.9 kW
Dimension One Spas
Export (50Hz
3.6 (2.0) HP
Export (50Hz
Note: 1. Subject to change without notice.
Doc-1514 Rev -B
Rev Date: 4/6/07
Specification, Triad II
Page 1 of 2
Triad II Specifications
Dimension One Spas
Triad II
Architectural Specification
Optional stereo
Sub-woofer location
Sequencer valve
compartment
26 in [67 cm]
Recommended location for
Electrical
Inlet
10 in [27 cm]
Hose Bib/
Water Drain
stereo speaker location
(optional)
THIS 3 FOOT SQUARE AREA,
ON BOTTOM OF SPA, TO BE
SUPPORTED CONSISTENT WITH
THE EDGES OF SPA BASE.
R16 in [R41 cm]
66 1/2 in [169 cm]
Shell
See Caution
66 in [168 cm]
Skirt
63 1/2 in [162 cm]
Pedestal
Base
Equipment
Compartment
Hose Bib/
Water Drain
3 1/2 in [9 cm]
Control Panel
Front Side of Spa
Vent
83 1/2 in [212 cm]
stereo speaker location
Control Panel
Pedestal Base
Door Extends
Under Spa Lip
Vent
58 in [147 cm]
(optional)
25 1/2 in [64 cm]
36 1/2 in [92 cm]
47 in [119 cm]
Spa Lip
Vent
30 1/2 in [77 cm]
26 1/2 in [67 cm]
Note: 1. Subject to change without notice.
2. Engineering specs may differ slightly from brochure.
3. For E-Z lifter installation allow 18” (45.7cm) clearance on the backside of the spa.
4. Alternative cabinets may add significant weight. Ask your dealer for exact details
5. This is the approximate location for drilling a hole if you must bring the power line in through the bottom of the spa.
Be careful not to puncture a plumbing line inside the equipment compartment(drill from the inside compartment out).
Caution:
Due to manufacturing tolerances there could be some
minor differences between the actual spa and the drawing above.
If site planning is critical to such tolerances, be sure to measure your actual spa.
67 in [170 cm]
83 in [210 cm]
Doc-1514 Rev -B
Rev Date: 4/6/07
Specification, Triad II
Page 2 of 2