Installation
Installation
Shut off water suppliers. Remove the old
faucet, clean the mounting surface.
Note: For first time install, flush the pipes
first by open the angel valve to run 60s.
For Three-Hole Sinks:
3
21
Remove the mounting hardware from the
mounting pipe.
For Three-Hole Sinks:
4
Adjust position of faucet body if necessary,
Then tighten the mounting nuts with phillips
screwdriver until snug.
87
Connect and tighten the supply hoses by using
two adjustable wrenches (avoid twisting or
kinking).
Note: Do not remove the net filter that
attached into the connecting end!
109
Click
Place stainless (non-staining) deck plate
and deck plate gasket onto sink, secure it
with silicone. Note: the deck plate need
purchase seprately.
For Single-Hole Sinks:
5 6
Put the rubber O-ring into the bottom gap of
faucets then Insert faucet into faucet hole.
Put the rubber O-ring into the bottom gap of
faucets then Insert faucet into faucet hole.
From underneath the countertop, Slide rubber
washer, metal washer and mounting bracket
onto the thread shank.
Turn on water suppliers. Place a bucket below
outlet tube, slowly open and close the supply
angle valves, This will prevent debris from
being lodged in the hose and sprayer.
11 12
Install the hose weight on the outlet side of
the hose, near the loop.
Test the handspray hose. If it does not
retract smoothly, reposition the weight.
Shut off water suppliers. Push the
handspray hose(7) into the quick
connector(10) until you hear a click sound.
Make sure it’s secured.
Turn on the water suppliers, Shut off the faucet
and check for leaks.
Loading...