Digit Z DZ4-600 User Manual

DZ4-600 Manual

I. Operation

1. Place the scale on a at, level surface and press the

ON/OFF key to turn the scale on.

2. Once the start-up process completes and the scale
goes to zero you are ready to weigh.

3. Place the quantity to be weighed onto the weighing
platform.

4. Wait a couple seconds for the display to stabilize
before taking a weight reading.

II. Changing the Unit of Measure

1. Press the MODE key to change the scales displayed
unit of measure.

2. If the scale is turned off then back on, it will default
to the last unit used.

• DZ4-600 Units: g (gram)

oz (ounce) ozt (troy

ounce) dwt (pennyweight)

III. Using the Tare Feature

You can use this scale’s tare feature to subtract the weight
of an empty container or vessel for net weight determination.
NOTE: The weight of the container will subtract from the
available capacity.

1. Place the empty container or vessel on the weighing
platform.

2. Press the TARE key once. The display will then
reset to zero. If the container is removed, it’s weight
will be displayed as a negative number.

3. You may now ll the container with the quantity to
be weighed. The display will show the net weight of

the contents.

4. To return to normal weight display (gross weight),

remove any items from the weighing platform and
press the TARE key again to re-zero the scale.

IV. Calibration / Adjustment

1. Press and hold the MODE key until the display
shows “CAL”.

2. Press the MODE key again. The display will ash
“CAL” followed by the calibration weight value (see
chart).

3. Place the calibration weight on the center of the
weighing platform. Make sure you are using the
correct weight for your specic model.

4. Once the weight is accepted, the display will show
“PASS” then return to normal operation.

V. Error Codes

1. OUTZ - Zero range has shifted. Perform calibration

adjustment. If the problem persists, the load cell may
be permanently damaged due to overloading.

2. O-Ld - Maximum capacity exceeded. Remove the
extra weight to avoid damaging the load cell.

3. UnST - Unstable. Use in a more stable position.

DZ4-600

Max. Capacity 600g

Readability 0.1g

Power Two (2) AAA Batteries

Dimensions 3.0 x 3.9 x 0.6 in.

Platform Dimensions 1.9 x 3.5 in.

Warranty 90 Day Limited Warranty

For warranty and support, please email

[e-mail]