Digitus Professional DN-80100 Service Manual
16-PORT GIGABIT + 2 SFP
ETHERNET SWITCH
User Manual
DN-80100
Chapter 1 Product Introduction
Congratulations on your purchasing of the Gigabit Ethernet Switch. Before you install and
use this product, please read this manual carefully for full exploiting the functions of this
product
1.1 Product Overview
16port 10/100/1000M + 2SFP Ethernet Switch provides the seamless network connection.
This device integrates 1000Mbps Gigabit Ethernet,100Mbps Fast Ethernet and 10Mbps
Ethernet network capabilities in a highly flexible package. The Switch with a low-cost,
easy-to-use, high performance upgrades your old network to a 1000Mbps Gigabit network.
Based on Gigabit Ethernet Technology, It is essential to helping solve network
bottlenecks that frequently develop as more advanced computer users and newer
applications continue to demand greater network resources. Support IEEE802.3az energy
efficient Ethernet (EEE),reduce power consumption by detection cable length and
operating loading, auto adjust signal intensity, Reduce energy consumption, and protect
the environment.
The switch is easy to install and use. It requires no configuration and installation. It is a
great selection for expanding office network.
.
1.2 Features
Comply with IEEE 802.3,IEEE 802.3u,IEEE802.3x,IEEE802.3ab,IEEE802.3az
standards
Supports up to 16K MAC address
Supports IEEE802.3x flow control for Full-duplex Mode and backpressure for
Half-duplex Mode
Support packet length 9216 bytes jumbo frame packet forwarding at wire speed
16 x 10/100/1000Mbps
Auto MDI/MDI-X Ethernet port
Two 1000Mbps SFP Slots
LED indicators for monitoring power, link/activity
1.3 Package Contents
One
One AC power cord
16 port Gigabit +2 SFP Slots Ethernet Switch
Four rubber feet, two mounting ears and eights screws
One User Manual
1
Chapter 2 External Component Description
2.1 Front Panel
The front panel of the Switch consists of series of LED indicators,16 10/100/1000Mbps
RJ-45 ports and 2 SFP ports a shown as below.
Figure 1 - Front Panel
10/100/1000Mbps RJ-45 ports (1~16):
Designed to connect to the device with a bandwidth of 10Mbps,100Mbps or 1000Mbps.
Each has a corresponding 10/100/1000Mbps LED.
SFP ports (SFP1, SFP2):
The interface card provides an interface so that you can insert a transceiver module (SFP)
into the interface and connect it to the interface of another switch with cables.
LED indicators:
The LED Indicators will allow you to monitor, diagnose and troubleshoot any potential
problem with the Switch, connection or attached devices.
Figure 2 - LED Indicators
2
Loading...