Page 1
Package Contents .......................................................................... Page 1
Network Card Installation ........................................................... Page 2
Connect to Wireless Access Point.................................................. Page 5
Quick Installation Guide
WIRELESS 300N AUTO INSTALLATION
USB ADAPTER
Page 2
1
Package Contents
Before you starting to use this wireless network card, please check if there’s anything missing in
the package, and contact your dealer of purchase to claim for missing items:
□ USB wireless network card (1 pcs) ……..………………………………………. 1
□ Protection Cap (1 pcs) …………………..………………………………………. 2
□ Quick installation guide (1 pcs) ………………………………………………… 3
□ User manual / device driver CD-ROM (1 pcs) …………….…………………….. 4
□ USB Cable (1 pcs) …………….…………………………………………………. 5
2
3
4
5
1
Page 3
2
Network Card Installation
Please follow the following instructions to install your new USB wireless network card:
1. Insert the USB wireless network card
into an empty USB 2.0 port of your
computer when computer is switched on.
Never use force to insert the card, if you
feel it’s stuck, flip the card over and try
again.
2. Install the adapter into your computer
and wait a few minutes for the system
starting to install the driver and utility
automatically.
3. The system will finish driver and
utility installation automatically.
Page 4
3
Connect to Wireless Access Point
Using Configuration Utility to Connect to Wireless Access Point
1. After installation is complete,
wireless configuration utility will be
shown in the desktop of your computer
automatically. You will also see an icon
at the lower-right corner of your
windows system. You can click the icon
by right mouse key, and select the
configuration utility you want to use or
switch the network card to AP mode.
2. Configuration utility will scan for
wireless access points and access to any
unencrypted wireless access point
automatically. If you wish to connect to
another access point, select the access
point and click ‘Connect’.
If the wireless access point you want to
connect does not show here, please
click ‘Rescan’.
Page 5
4
3. If the wireless access point uses
encryption, you have to input WEP key
or WPA preshared key. Please ask the
owner of the wireless access point you
want to connect and input the correct
key here, and then click ‘OK’. If the
value you inputted here is wrong, you
will not be able to connect to wireless
access point.
Authentication type is selected
automatically, please don’t change it.
4. If the wireless access point is
successfully connected, you’ll see a
symbol appears in front of the name of
wireless device.
For advanced settings and other features of this USB wireless network card, please refer to user
manual enclosed in supplied CD-ROM.
Loading...