Digitus DS-31220 Service Manual

Page 1
USB 3.0 - 2 ports
ExpressCard
User Manual
All brand names and trademarks are properties of their
respective owners.
Page 2
Features and Benefits
Fully compliant with ExpressCard Specification 1.0  ExpressCard/34 form factor module  Compliant with Universal Serial Bus 3.0 specification
revision 1.0
Supports simultaneous operation of multiple USB 3.0, USB
2.0 and USB 1.1 devices
Supports USB data transfer rate of 1.5/12/480/5000 Mbps  Expands two external USB 3.0 Super-Speed ports on the
system
Built-in DC Jack connector for receiving extra power to
meet USB 3.0 +5V/900mA power output standard
Hot-swapping feature allows you to connect/disconnect
devices without powering down the system
Bus Interface
ExpressCard 34mm Wide
Connector
2 x Downstream ports
Page 2
Page 3
System Requirements
Windows® XP/Vista/7 (32/64 bit)  ExpressCard-enabled system with the an available
ExpreeCard slot
Package Contents
1 x USB 3.0 2 ports ExpressCard  1 x User Manual  1 x Driver CD
Note: Contents may vary depending on the market/country.
Hardware Installation
General instructions for installing the card are provided below. Since the design of system may vary, refer to your system’s reference manual for further information, if needed. Insert the Card into the ExpressCard slot of your system. Make sure it is inserted all the way in for a solid connection.
Driver Installation
Page 3
Page 4
Important: If your system doesn’t boot to Windows properly with our card installed, check with your system’s manufacturer for the latest system firmware update.
For Windows® XP/Vista/7 (32/64 bit)
Place the insta llation C D into a CD-ROM drive and setup s hould launch automatically. If setup does not launch, use Windows Explorer to native to the appropriate CD-ROM driver and run the installation program. Follow the instructions on screen to install the driver. Aft er driver installation is complete, you must restart your computer.
To Verify Driver Installation
1. Right click My Computer, then click Manage. Click Device Manager.
2. Double click Universal Serial Bus controllers option.
- NEC Electronics USB 3.0 Host Controller
- NEC Electronics USB 3.0 Root Hub
Page 4
Loading...