
Features
Fully compliant with PCI Express Base Specification Revision 2.0
Single-lane (x1) PCI Express throughput rates up to 5 Gbps
Compliant with Universal Serial Bus 3.0 specification Revision 1.0
Supports simultaneous operation of multiple USB 3.0, USB 2.0 and
USB 1.1 devices Supports the following speed data rates as
follows: Low-speed (1.5Mbps) / Full-speed (12Mbps) / High-speed
(480Mbps) / Super-speed (5Gbps)
Supports 2 downstream ports for all speeds
Built-in 4-pin power connector for receiving extra power supply from
system
Hot-swapping feature allows you to connect/disconnect devices
without powering down the system
Support Windows® XP/Vista/7 (32/64 bit)
System Requirements
Windows® XP/Vista/7 (32/64 bit)
One available PCI Express slot (Recommend PCI Express 2.0)
Package Contents
1 x USB 3.0 2-Port PCI Express Card
1 x Driver CD
1 x User Manual
Hardware Description

Hardware Installation
1. Turn Off the power to your computer.
2. Unplug the power cord and remove your computer’s cover.
3. Remove the slot bracket from an available PCIe slot.
4. To install the card, carefully align the card’s bus connector with the
selected PCIe slot on the motherboard. Push the board down
firmly.
5. Replace the slot bracket’s holding screw to secure the card.
6. Replace the computer cover and reconnect the power cord.
Driver Installation
For Windows
®
XP/Vista/Win7 (32/64 bit)
1. Please insert the CD driver bound with USB 3.0 2-Port PCI
Express Card into your CD-ROM Drive.
2. At the Windows desktop, click Start, Run.
3. Type D:\RENESAS NEC uPD720200F1\Setup.exe, click OK.
(Change D: to match your CD-ROM drive letter)
4. Follow the on-screen instructions to complete the installation.
To Verify Driver Installation
Click on the “Device Manager” tab in System Properties, which you
access from the Windows Control Panel. You should see a “NEC
Electronics USB 3.0 Host Controller” and a “NEC Electronics USB
3.0 Root Hub” under the “Universal Serial Bus controllers” item.