Digitus DS-30220 operation manual

USB 3.0 2 ports

PCI Express Card

User Manual

All brand names and trademarks are properties of their

respective owners.

Features and Benefits

 Compliant with Universal Serial Bus 3.0 specification

revision 1.0

 Supports the following speed data rates as follows:

Low-speed (1.5Mbps) / Full-Speed (12Mbps) / High-Speed
(480Mbps) /Supper-Speed (5Gbps)

 Supports 2 downstream ports for all speeds
 Supports all USB compliant data transfer types as follows:

Control /Bulk /Interrupt / Isochronous transfer

 Supports USB legacy function
 Compliant with PCI Express Base Specification 2.0
 Supports PCI Bus Power Management Interface

Specification revision 1.2

Bus Interface

 PCI-Express x 1

Connector

 2 x Downstream ports

Page 2

System Requirements

 Windows® XP/Vista/7 (32/64 bit)
 PCI Express-enabled system with an available PCI Express

slot

Package Contents

 1 x USB 3.0 2 ports PCI Express Card
 1 x User Manual
 1 x Driver CD
 1x Low-Profile bracket

Note: Contents may vary depending on the market/country.

Hardware Installation

1. Turn Off the power to your computer.

2. Unplug the power cord and remove your computer’s cover.

3. Remove the slot bracket from an available PCIe slot.

4. To install the card, carefully align the card’s bus connector
with the selected PCIe slot on the motherboard. Push the
board down firmly.

Page 3

5. Connect the system power source to the board’s power
connector.

6. Replace the slot bracket’s holding screw to secure the card.

7. Replace the computer cover and reconnect the power cord.

Driver Installation

Important: If your system doesn’t boot to Windows properly with
our card installed, check with your system’s manufacturer for the
latest system firmware update.

For Windows® XP/Vista/7 (32/64 bit)

Place the installation CD into a CD-ROM drive and setup should
launch automatically. If setup does not launch, use Windows
Explorer to native to the appropriate CD-ROM driver and run the
installation program.
Follow the instructions on screen to install the driver. After driver
installation is complete, you must restart your computer.

Page 4

To Verify Driver Installation

1. Right click My Computer, then click Manage. Click Device

Manager.

2. Double click Universal Serial Bus controllers option.

- NEC Electronics USB 3.0 Host Controller

- NEC Electronics USB 3.0 Root Hub

Page 5