4 Ports
Fast Ethernet PoE Switch
Manual
DN-95322
4 Ports PoE Ethernet Switch
4 ports PoE Ethernet Switch is a security surveillance Ethernet Switch which
aims at Ethernet high definition surveillance and Ethernet project security
system. The product fully combines the characteristics of security surveillance,
provides fast packet forwarding ability and abundant backplane bandwidth,
which ensures clear image and fluent transmission. Inserted static, surge
protection circuit can improve product stability. The product supports one key
VLAN mode, can achieve VLAN, QoS priority after configuration, control the
Net storm, protect the information security, prevent the viral transmission and
Ethernet attack, fully satisfy the Ethernet video security surveillance system
and Ethernet project needs.
Feature
1. Major ports: 1 pc 100Mbps up link Ethernet port, 4 pcs 100Mbps down
link Ethernet ports , every port supports MDI/MDIX
2. Special function: One key VLAN mode
1～4 downlink ports can only communicate with uplink port
3. Power input: DC48V～57V
4. Transmission Distance : Ethernet port 0～100m
5. Standard: Meet IEEE802.3 ,IEEE802.3u,IEEE802.3 af/at standards,
PoE use End-Span, the spare cable can be of other use
6. Protection: Excellent anti-thunder, anti-static and anti-interference ability
7. Appearance: Delicate design and easy installation, configure the anti-theft
lock hole, guard against theft
8. Operation: Plug and Play, No Setting required
Notice
The transmission distance is related to the connected cable. We
suggest standard Cat5e/6 network cable, so the transmission
distance can up to100m!
Board diagram
Description
1) The equipment must connect the ground according to the request.
2) Turn the dial switch for left, the equipment can enter surveillance module
after providing equipment power.
Installation steps
Please check the following items before installation. If any missing, please
contact the dealer.
Please check the following items before installation, if it is missing, please
contact the dealer.
4 ports PoE Ethernet Switch 1pc
Power adaptor 1pc
AC power cable 1pc
Accessory 1set
User manual 1set
Please follow the below installation steps:
1. Please turn off the signal power and display device power before
installation, installation with power will damage the transmission
equipment
2. Use network cable connect PoE IP camera and 1～4 down link ports of
product respectively
3. Use a network cable connect equipment up link port and NVR or computer;
4. Turn on the power of the equipment
5. Check if the installation is correct, equipment is in good condition, the
connection is stable, then provide power for system
6. Ensure the Ethernet equipment with power and work properly.
Specification
Product is subject to change without prior notice.
Trouble Shooting
1. Make sure the equipment is installed according to the manufactures
installation guide.
2. Confirm RJ45 cable order meets EIA/TIA568A or 568B standard.
3. Every PoE port can provide PoE equipment maximum power less than
30W; please do not connect the PoE equipment with power over 30W.
4. Replace the equipment with a proper functioning 4 ports PoE Ethernet
Switch to check if the equipment is damaged.
5. Please contact your vendor if trouble still exists.
Loading...