Page 1
Fast Ethernet PoE + Repeater
Manual
DN-95122
Page 2
PoE Ethernet Repeater
The POE Ethernet repeater extend Ethernet signal to 100 meters, greatly
extending the transmission distance and providing PoE at the same time. It is
widely used in security surveillance and network project.
Feature
1. Provide 3x 10/100Mbps Ethernet ports, one PoE input port, two PoE
output ports, which can meet the requirements of local monitor, long
distance transmission and PoE power supply
2. Use advanced network cable driving technology
3. PoE power supply is compatible with End-span and Mid-span
4. Meet standards of IEEE802.3, 10 BASE-T, IEEE802.3u, 100 BASE-TX,
IEEE802.3af/at
5. Excellent circuit isolation protection, effectively improve product's lightning
protection
6. ESD and anti-interference ability
7. Appearance and structure: solid and delicate, easily install on the wall and
desktop
8. Operation: plug and play, no setting required
Notice
Please use standard Cat 5e/6 cable to get the longest transmission distance!
Page 3
Board diagram
Notice：
Device must be connected with lightning protection grounding; otherwise
protection level will reduce; please use above No.20 wire to connect the
grounding terminal.
Instruction
Installation steps
Please check the following items before installation. If any missing, please
contact the dealer.
POE Ethernet Repeater 1 pc
MIT Hangers 2 pcs
User Manual 1 pc
Page 4
Please follow below the installation steps:
1) Please turn off the signal source and the device's power; installation with
power on may damage the device
2) Check if the network cable and other transmission line that will be used are
not occupied by other device
3) Use a network cable to connect PoE Ethernet repeater's POE IN port with
PoE Ethernet switch
4) Use 2 network cables to connect 2 PoE IP cameras with PoE Ethernet
repeater's PoE output port respectively
5) Check if the installation is correct, make sure all the connection are reliable
and power up the system
6) Make sure the network is normal
Specification
Product is subject to change without prior notice.
Page 5
Trouble Shooting
1. Please check if the installation is correct
2. Please check if the RJ45 cable order is in accordance with the
EIA/TIA568A or 568B industry standards
3. The maximum transmission distance depends on the signal source and
cable quality, please do not exceed the maximum transmission distance
4. Please replace a failure device with a normal one to check if the device
is broken
5. If the problem still exists, please contact the factory
Table 1: Relationship between Single Port power and distance, power divides
equally when dual ports work.
Description:
The test data in table 1 gained through the test method in Picture1.
Loading...