Digitus DN-93601 Installation Guide

Keystone Jack

Installing Instruction

DN-93601

1

Strip approximately 30mm of the cable jacket,
and separate to 4 pair each

30 mm

3

Follow the direction on the colorcoding
sticker to position T568A or T568B wiring,
separate a little space on proper position
and insert the wire pair by pair into each
slot.

2

T568A

Pin 5 White/Blue
Pin 4 Blue
Pin 1 White/Green
Pin 2 Green
Pin 3 White/Orange
Pin 6 Orange
Pin 7 White/Brown
Pin 8 Brown

Unshielded type

4 5

Use 110 or KRONE impact tool to
press and cut off each conductor.

T568B

Pin 5 White/Blue
Pin 4 Blue
Pin 1 White/Orange
Pin 2 Orange
Pin 3 White/Green
Pin 6 Green
Pin 7 White/Brown
Pin 8 Brown

I.D.C. Cable tie

Insert the IDC cap to x these
wires. Insert the cable tie to tight
up the cable jacket and complete
the installation.

Shielded type

3

Slide the cable jacket into
Cable Holder.

4

Follow the direction on the color coding
sticker to position T568A or T568B wiring,
separate a little space on proper position
and insert the wire pair by pair into each
slot. Use 110 or KRONE impact tool to
press and cut off each conductor

5

Insert the cable tie to tight up the cable
jacket. Insert the IDC cap to x these
wires.

I.D.C. Cable tie

6

Cover the Full shield, then
complete the installation.

( Note: Full shield has to insert into this plastic slot )