
2.5" SSD/HDD Enclosure SATA 3 ─ USB 3.0
Manual
DA-71105
Introduction
Congratulations on your purchase of this Portable USB3.0 Hard Drive Enclosure. It's a
great way of making a lightweight, portable mass storage device with an unused
internal hard drive that will be detected and installed automatically by your
computer when it connected. Depending on the capacity of the drive used,
you can keep large files, or run programs and play videos directly. It can also be used
as a backup drive to your computer or other devices.

Specification
Transfer interface USB3.0
Transfer rate 5Gbps (MAX)
Support HDD 2.5"/3 . 5 " Hard disk
Work temperature -40~65 °C
Work humidity 8%~90%
Storage humidity 5%~95%
Operate system Windows 2000/XP/VISTA/WIN7/8/10
System Requirements
Hardware: computer should have USB port
Software: Windows 2000/XP/VISTA/WIN7/8/10
Note: Windows98 have to install CD Driver
(use the CD Driver in accessories to install)
Installation
Installation of Windows SE/ME/2000/XP/VISTA/WIN7/8/10
Operation System
No driver program is necessary
Connect the USB cable to PC
Click”My computer”and hard-disc will appear
An icon for online plug should appear on the lower right corner of the status bar
(new hard-disc should be divided into sections with FDISK first, then its icon will
appear and normal operation can start after formatting.)

Installation of Hard Drive
1. Open the enclosure
2. Place hard drive into the enclosure
3. Connect included IDE or SATA cable to hard drive
4. Tighten screws on the enclosure to hold the hard drive in place
5. Screw the enclosure back together
6. Connect power cable to enclosure
7. Connect USB cable to USB port on device
8. When attached to PC or device, click 'My Computer' and hard
drive will appear.
9. No additional drivers required.
Hereby ASSMANN Electronic GmbH, declares that this device is in compliance with the requirements of
Directive 2014/30/EU and the Directive 2011/65/EU for RoHS compliance. The complete declaration of
conformity can be requested by post under the below mentioned manufacturer address.
Warning:
This device is a class B product. This equipment may cause some radio interference in living environment. In
this case, the user can be requested to undertake appropriate measures to prevent interference.
www.assmann.com
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
Germany