Digitus DA-70613 User guide

Page 1
Safety socket for flush mounting
with 2 USB ports
Manual
DA-70613
Page 2

A. Package Content

Safety socket for flush mounting with 2 USB ports
Mounting instruction

B. Connections

1. Turn power off before installation.
2. To connect the base as shown in Diagram A before installing in into
the mounting boxes, make sure there is no wire exposed at the connection. Note the phases cannot be ground trough to another safety wall outlet nearby. We recommend installing the safety outlet at the end of the row.
(ATTENTION: the cross-sectional area of wire connect power is at least
1.5mm^2 not exceed 2.5mm^2
3. To fix the "base part", by using the screw or claw as Diagram B or Diagram C shown, and then insert the “frame” into the “base” part.
3.1 For:
2
Page 3
SMPS incorporating a Short-circuit-proof safety isolating transformer (inherently or non-inherently)

C. Important Notes

1. DO NOT OVERLOAD.
2. To install the product properly, it needs to instruct by a qualified electrician.
3. The symbol in manual
For indoor use only
SMPS (switch mode power supply unit)
Symbol for class II
E Protective earth
Protective earth
3
Page 4

D. Warning

www.assmann.com
Germany
For your safety, please read the following cautions before installing or using your device.
1. Do not open the device or attempt to repair it.
2. Use the device in a dry location, and avoid placing it in a humid environment.
3. Do not submerge the device in liquid or attempt to clean it with liquids or solvents. To clean the device, disconnect it from the power outlet and use a damp towel.
4. This device should only be used indoors.
5. USB Charger Adaptor for IT-equipment: do not exceed the total max output from both USB outputs.

E. Energy efficiency

Input:250V~, 50Hz, Max 0.20A
Output: 5.0V DC 2.1A, Max 10.5W
Average active efficiency: 81.8%
Efficiency at low load (10 %): 77.3%
No-load power consumption: 0.09W
Hereby Assmann Electronic GmbH, declares that the Declaration of Conformity is part of the shipping content.
If the Declaration of Conformity is missing, you can request it by post under the below mentioned
manufacturer address.
Assmann Electronic GmbH
Auf dem Schüffel 3
58513 Lüdenscheid
4
Loading...