Digitus DA-70547 User manual

USB 3.0 DUAL SATA HDD

DOCKING STATION

User Manual

(DA-70547)

Introduction

DA-70547 is a USB3.0 enabled dual-SATA hard drive enclosure. It supports
simultaneously use of two 2.5” or 3.5” SATA hard disk for both data read and data
write. It also is downward compatible with USB2.0 and USB1.1. The maximum
transfer speed of USB3.0 can reach 5Gbps. The actual transfer speed of DA-70547 is
200M/s. DA-70547 provides high storage capacity, high data transfer rate, and best
data protection. It’s easy to use the design which can satisfy both regular users and
professionals of the ever-increasing demand for large and efficient data storage
media.

Function

 Support USB3.0 SUPERSPEED mode max 5Gbps/ USB2.0 HIGH-SPEED mode

480Mbps/USB1.1 FULL-SPEED 12Mbps

 Support SATA I (1.5G) / SATA (3G) HDD

 Achieves transfer speeds of up to 200MB/s

 Downwards compatible with any USB2.0 enabled computers and notebooks

 Easy to Install and Set-up

 To achieve USB3.0 transfer speeds, a USB3.0 interface card with USB3.0 cable is

required

 Supported OS: Windows 7 (32/64-bit), Vista (32/64-bit), XP(32/64-bit)

One Touch Back-Up function
User’ s Manual
Notice

 The type of file system is able to support FAT32 and NTFS both..

 When users operate the PC Clone EX Lite, the login must be from Administrator; it

can not login from the Guest or any authorized account.

 Does the hard disk happen to the bad sector? Please confirm in advance that can

prevent an improper operating of backup or restore.

System Requirements

 Pentium computers or 100% compatible computers.

 Support OS: Microsoft Windows 98SE/ME/200/XP/Vista/7.

 CPU Pentium or above

 128 MB RAM

 Display card: compatible with VESA standard

 An external USB hard disk

Software installation

1. Please put PCClone EX Lite CD into CD ROM drive, the program directly goes on the

screen of PCClone Setup Wizard. (In case the screen doesn’t come out, please

operate the window box of “setup.exe”)

2. Click “install’.

3. Please read the license agreement in detail

4. If users accept the agreement, please click “Next” to install

5. Click “Install” to next

6. The installation is completed, please click “OK” to exit.

7. “PCClone EX”icon will displays in the notification area after setup; users can

double-click the icon or press the right key of the mouse to execute PCClone EX Lite.

Create Partition

If your USB HDD has managed already, please skip this part and move on next context.

Steps

1. Please plug USB HDD. (Turn on the USB power)

2. Please right click “My computer”, and point “Manage”. (If also can click in succession

as “Start”→ “Control Panel”→ “Administrative Tools”→ “Computer Management” (If

your USB HDD has managed already, please skip this part and move on next context)

3. Please click “Disk Management” as the left window, and then find the disk

management as the right window.

4. Please right click the disk of “Unallocated”, and point the “New Partition”. (In order to

make sure the disk of “Unallocated” whether the USB disk uses this area or not, users

can find out by removing and plugging the port of USB connection)

5. Follow up the installation of “Partition Wizard” to operate the disk of partition and

format