LAN and USB External
3,5" HDD Enclosure
User’s Manual
DA-70516
CONTENT
1. Product Information………………………….…....1
2. Product Specifications……………………….…….2
3. System requirements……………………….….…..3
4. Take a look to the Product………….….….….... 4
5. Product Assemble Step…….……………………...5
6. Product Connecting…….……………………..…...8
7. Driver Installation (USB2.0) ………….….….….9
8. Verification…………………………….….…....….13
9. Configuring LANDISK………………………..…..14
10. Note…………….……………….……………………23
1. Product Information
• Personal Internet & Intranet Storage
• Samba Server + FTP Server
• No need to install any O.S, Virus free
• Low Cost and Simple Installation
• Low Power Consumption, Low Heat Dissipation
• Serve Cross-Platform Client O.S.
• Web Browser Management User Interface
• Multi Protocol Support: TCP/IP, HTTP, SMB, FTP
• Support DHCP / Fixed IP Address
• USB2.0 High-speed data transfer rate up to 480 Mbytes
• 64/512 bytes data payload for full/high speed bulk endpoint
• Supports 8-bit/16-bit standard PIO mode interface
• USB2.0 high-speed interfaces & RJ45 for barrier-free data
transfer
• Supports power down mode and USB suspend indicator
Product Specifications:
• Network Connection Method
Available network environment, 100BASE-TX/10BASE-T,
Connection type, RJ-45
• Supported Protocols
TCP/IP, NBNS (Net BIOS Name Server), Microsoft Networks
(CIFS/SMB), HTTP 1.0 and HTML 2.0, DHCP Server/Client (Auto
detection), SNTP Client and Telnet Server
• Supported Operating Systems
Microsoft Windows: 98SE, ME, 2000, XP
MAC OS X (10.3.X or above versions)
• IP Acquisition Method
Automatic (DHCP)/Manual (Static setting)
• Supported Hard Drive Specifications
Ultra ATA / 133 (must be DMA compatible)
• Partition Configuration
1
FAT32 (4GB Max File Size)
3. System requirements
Windows 98SE / 2000 / XP:
Pentium II 233MHz equivalent or higher
64 MB RAM (128 MB recommended)
USB 1.1 Port (USB 2.0 recommended)
CD-ROM drive for installation (Win 98SE only)
RJ45 network port for NDAS mode
Mac OS X:
G4 processor or higher running OS X 10.2 or higher
128 MB RAM (256 MB recommended)
USB 1.1 Port (USB 2.0 recommended)
RJ45 network port for NDAS mode
4. Take a look on the Product
1 System LED
2 Link LED
3 Power LED
4 Working LED
5 Reset to FactoryDefault
(Power on, press 15sec )
6 Receptor of Power Adapte
7 USB Port: USB1.1/USB2.0
8 LAN Port: 10/100 Base-TX
2 3
5. Ptep
1) Take off the front panel, pull out the product module from
the housing.
2) Set your IDE hard drive as “Master/Single” mode.
3) Connect IDE cable and 4-pin power adapter cable on your
hard drive.
4) Use the screws to fix it firmly.
5 4
Loading...