Digitus DA-70148-1 operation manual
User's Manual
USB 2.0 TO IDE & SATA Cable
1. Characteristics
Support SATA spread-spectrum transmitter
Support SATA II Asynchronous Signal Recovery (Hot Plug) feature
Compliance with USB 2.0 (Hi-Speed USB) electrical specification
Compliance with USB Mass Storage Class Bulk-Only Transport Specification
Support 480Mbps High Speed (HS) and 12Mbps Full Speed USB operation
Support A T A/A TAPI-7
Support ATA/ATAPI Ultra DMA Mode
Support ATA/ATAPI PACKET command feature set
Support ATA/ATAPI LBA48 addressing mode
Support dual LUN (Logic Unit Number) for USB to ATA/ATAPI
Support Windows 98se, Windows ME, Windows 2000, Windows XP, Windows 7
Need driver installation under Windows 98se
1. Before Installation
Please put this USB HDD connect to IDE&SATA Cable, please reference as below:
If you need connect 3.5’’ IDE HDD, please reference as below :
Step 1: Please plug USB TO IDE&SATA CABLEL connect to HDD，HDD should connect power adapter.
Step 2：Please put the USB of USB2.0 To IDE&SATA connect to computer’s USB.
Step 3：Reference “Inspect connect ’s correction”
If you need connect 2.5” IDE HDD, please reference as below:
Step 1：Please put the Power Cable “4P” to “2P” connect to USB TO IDE&SATA Cable, please reference:
Step 2: Please plug USB To IDE&SATA Cable to 2.5” HDD, please reference:
Step 3: Please plug the USB of USB To IDE&SATA Cable into computer,
Step 4: Reference “Inspect connect ’s correction.”
If you need connect SATA HDD, please connect as below:
Step 1:Please connect the wire of SATA Cable to USB To IDE&SATA Cable and SATA HDD, please reference:
Step 2: Connect HDD and Power adapter, please reference:
Step 3: Please put the USB of USB To IDE&SATE Cable into computer;
Step 4: Reference “Inspect connect ’s correction.”
2. Software Installation
Windows 98se
1) Please put the enclosed CD into the CD-ROM
Cable
2) Please plug this USB HDD in the USB port of your computer.
3) The system will detect it and display the "Add New Hardware Wizard" dialog, please press "Next"
Loading...