DIGITECH Audio AR1756 Instruction Manual

DIGITAL RADIO

INCLUDING FM, DAB AND DAB+

INSTRUCTION MANUAL

Safety Precautions

To achieve the utmost in enjoyment and performance, and in order to become familiar with its
features, please read this manual carefully before attempting to operate the unit, this will assure
you years of faithful, trouble free performance and listening pleasure.

Important Notes

• This safety and operating instruction should be retained for future reference.

• The apparatus shall not be exposed to dripping or splashing and that no objects filled

with liquids, such as vases, shall be placed on apparatus.

• Avoid installing the unit in locations described below:
o Places exposed to direct sunlight or close to heat radiating appliances such as

electric heaters.

o On top of other stereo equipment that radiate too much heat.
o Places blocking ventilation or dusty places.
o Places subject to constant vibration.
o Humid or moist places.

• No naked flame sources such as lighted candles should be placed on or near the unit.

• The use of apparatus in moderate climates.

• Operate turning controls and switches as instructed in the manual.

• Before turning on the power for the first time, make sure the power cord is properly

installed.

For safety reasons, do not remove any covers or attempt to gain access to the inside of the
product. Refer any servicing to qualified personnel.
Do not attempt to remove any screws, or open the casing of the unit; there are no user
serviceable parts inside, refer all servicing to qualified service personnel.

CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR
BACK), NO USER SERVICEABLE PARTS INSIDE, REFER SERVICING TO QUALIFIED
SERVICE PERSONNEL.

Dangerous Voltages, that may be of sufficient magnitude to constitute a risk
of electric shock to persons is present within this product’s enclosure.

The owner’s manual contains important operating and maintenance
instructions, for your safety, it is necessary to refer to the manual.

WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE
TO DRIPPING OR SPLASHING.

NOTE: This unit will become warm when used for a long period of time. This is normal and
does not indicate a problem with the unit.

DANGEROUS VOLTAGE

ATTENTION

ii

Safety Information

Some Do’s And Don’ts On the Safe Use Of Equipment

This equipment has been designed and manufactured to meet international safety standards
but, like any electrical equipment, care must be taken if you are to obtain the best results and
safety is to be assured.

DO read the operating instructions before you attempt to use the equipment.

DO ensure that all electrical connections (including the mains plug, extension leads and inter-

connections between the pieces of equipment) are properly made and in accordance with the
manufacturer’s instructions. Switch off and withdraw the mains plug before making or changing
connections.

DO consult your dealer if you are ever in doubt about the installation, operation or safety of your
equipment.

DON’T remove any fixed cover as this may expose dangerous voltages.

Overheating will cause damage and shorten the life of the equipment.

DON’T allow electrical equipment to be exposed to dripping or splashing, or objects filled with
liquids, such as vases, to be placed on the equipment.

DON’T place hot objects or naked flame sources such as lighted candles or nightlights on, or
close to equipment. High temperatures can melt plastic and lead to fires.

DON’T use equipment such as personal stereos or radios so that you are distracted from the
requirements of traffic safety.

DON’T listen to headphones at high volume, as such use can permanently damage your
hearing.

DON’T leave equipment switched on when it is unattended unless it is specifically stated that it
is designed for unattended operation. Switch off using the switch on the equipment and make
sure that your family knows how to do this. Special arrangements may need to be made for
infirm or handicapped people.

DON’T continue to operate the equipment if you are in any doubt about if it’s working normally
or if it’s damaged in any way. Switch it off and withdraw the mains plug and consult your dealer.

ESD Remark: In case of malfunction due to electrostatic discharge just reset the product
(reconnection of power source may be required) to resume normal operation.

NOTE: Do not open any covers and do not repair by yourself. Qualified personnel must carry
out repair work.

iii

Contents

Safety Precautions ii
Safety Information iii
Contents i
Package Content 2

Controls Overview (a) .........................................................................................................3

Controls Overview (b) .........................................................................................................4

DAB+, DAB mode 5

How to Get Start? ................................................................................................................5

How to Show the Signal Strength?......................................................................................5

DAB+/DAB Menu Tree ......................................................................................................6

How to Update Station list? .................................................................................................6

How to Set DRC (Dynamic Range Control) Value? ...........................................................7

How to Shift the DAB Station Information? .......................................................................8

FM Mode 9

How to Switch to FM Mode? ..............................................................................................9

FM Menu Tree.....................................................................................................................9

How to Display FM Station Information? .........................................................................10

How to Set Scan to only Strong Stations available?..........................................................10

Common Operation 11

Setting Station Presets .......................................................................................................11

Selecting a Preset station ...................................................................................................11

Volume Control .................................................................................................................11

System setup 12

How to Enter System Setup? .............................................................................................12

How to Set Sleep?..............................................................................................................12

How to Set Time? ..............................................................................................................13

How to Setting Alarm? ......................................................................................................14

How to Set Backlight? .......................................................................................................15

How to do Factory Reset?..................................................................................................16

How to Get SW Version? ..................................................................................................16

Specification 17

Contents page

Package Content

Digital Radio

DC Adapter

Instruction

manual

2

Controls Overview (a)

DIGITAL RADIO FRONT VIEW

Battery Door

DIGITAL RADIO BACK VIEW



Note

: For operate Software Program Jack, only limited to its original manufacturer.

• Battery Operation (Batteries Not Included)



Note: a. Before installing batteries, ensure that the radio is disconnected from the mains supply. Please do not
mix old and new batteries.

1. Remove the battery door at the back of the radio, refer to above DIGITAL RADIO BACK VIEW.

2. Referring to the markings inside the battery compartment, fit 6 pcs new 1.5V UM3/SIZE AA batteries,
remember position the red riband under batteries, and have this riband end exposing, this red riband
is designed for you to easy draw old batteries out.

3. Replace the battery door to cover the batteries and red riband.

4. Switch off the mains supply and remove the cable from the power socket. Battery operation will be
selected automatically.

5. If you are not going to use the radio for an extended period, please remove the batteries to avoid
damage.

3