Digital Watchdog MC352-29, MC352 Instruction Manual

INSTRUCTION MANUAL

Before installing and using the c am er a, pleas e r ead thi s manual
carefully. Be sure to keep it handy for l ater reference.

■ Do not open or modify
Do not open the cabinet exit during maintenance and
installation, as it may be dangerous and cause damages.

■ Do not put objects insi de the uni t
Make sure that no metal objects or flammable substances get inside
the camera. It could cause fire, short- ci r c uits or damages.

■ Be careful when handling the unit
To prevent damage, do not drop the camer a or subjec t
it to strong shock or vibration.

■ Install away from el ectr i c or magneti c fiel ds

■ Protect from humi dity and dust

■ Protect from high temper atur e

Be careful when installing close to the ceiling , i n a kitchen or boiler
room, as the temperature may raise to high levels.

■ Cleaning
Dirt can be removed from the cabinet onl y by wi pi ng it
with a soft cloth moistened with a soft deter gent solution.

■ Mounting Surface
The mounting surface material must be strong enough to secure the
camera.

INSTALLATION

WARRANTY INFORMATION

“

”

This warranty gives you specific l egal r i ghts and you m ay al s o have
other rights that vary from state to state.
If the problem is not handled to your satisfacti on, then write to the

PRECAUTIONS

MC352 /MC352-29

About this manual

5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support : 1-866-446-3595 / 813-888-9555

Before installing and using the c am er a, pleas e r ead thi s manual
carefully. Be sure to keep it handy for l ater reference.

TROUBLESHOOTING

Before sending the camera out for repai r , c heck the i tem s below . I f the
problem persists after checking these items, contact your service
center.

■ If no image appears.

Is the coaxial cable attached secur ely ?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (wi th the level vol um e) ?
Is there adequate illumination?

■ If the image is unclear

Is the lens in focus?
Is the lens dirty?
Dirt of fingerprints on the lens can adversel y affect the
images. Gently wipe any dirt or fingerprints off the lens
with a soft cloth or lens cleaning paper and cl eani ng
fluid (commercially available).
Is the monitor adjusted correctly?

WARNING:
TO PREVENT THE RISK OF FIRE O R ELECT RIC
SHOCK, DO NOT EXPOSE THI S A PPLI A NCE T O
RAIN OR MOISTURE.

■ Do not open or modify
Do not open the cabinet exit during maintenance and
installation, as it may be dangerous and cause damages.

■ Do not put objects insi de the uni t
Make sure that no metal objects or flammable substances get inside
the camera. It could cause fire, short- ci r c uits or damages.

■ Be careful when handling the unit
To prevent damage, do not drop the camer a or subjec t
it to strong shock or vibration.

■ Install away from el ectr i c or magneti c fiel ds

■ Protect from humi dity and dust

■ Protect from high temper atur e

Be careful when installing close to the ceiling , i n a kitchen or boiler
room, as the temperature may raise to high levels.

■ Cleaning
Dirt can be removed from the cabinet onl y by wi pi ng it
with a soft cloth moistened with a soft deter gent solution.

■ Mounting Surface
The mounting surface material must be strong enough to secure the
camera.

INSTALLATION

WARRANTY INFORMATION

Digital Watchdog (referred to as “the Warrantor”) warrants the

Camera Series against defects in materials or workmanship as follows:
LABOR: For the initial five (5) years from the date of ori gi nal pur c hase,
if the camera is determined to be defective, the Warrantor will repair or
replace the unit, with
new or refurbished product at its option, at no charge.
PARTS: In addition, the Warrantor will supply r epl acem ent par ts for the
initial five (5) years. To obtain war r anty or out of w ar r anty serv ic e,
please contact a Technical Support Representative at 1-866-446-3595
Monday through Friday from 9:00 AM to 5:00 PM Eastern.
A purchase receipt or other proof of the date of the or i gi nal pur c hase is
required before warranty service is rendered. This warranty only
covers failures due to defects i n mater ial s and wor k m anshi p w hic h
arise during normal use. Thi s war r anty does not cov er dam age w hic h
occurs in shipment or failures which are caused by products not
supplied by the Warrantor or failur es which result from accident,
misuse, abuse, neglect, mishandling, mis applicati on, alter ation,
modification, faulty installation, set- up adjustm ents, im proper antenna,
inadequate signal pick up, m al adjus tm ent of c onsum er contr ol s ,
improper operation, power l ine s ur ge, i m pr oper v ol tage s uppl y,
lightning damage, rental us e of the pr oduct or serv i ce by anyone other
than an authorized repair facility or damage that is attributable to acts
of God.

This warranty gives you specific l egal r i ghts and you m ay al s o have
other rights that vary from state to state.
If the problem is not handled to your satisfacti on, then write to the
Address above.

Service calls which do not involv e defective materials or workmanship
as determined by the Warrantor, in its sole discretion, are not covered.
Costs of such service calls are the r espons i bility of the purchaser.

LIMITS AND EXCLUSIONS

There are no express warranti es ex cept as listed above. The Warrantor
will not be liable for incidental or consequential damages (including,
without limitation, damage to r ecor di ng m edi a) resul ti ng from the use of
these products, or arising out of any br each of the w ar r anty. All expres s
and implied warranties, i ncl udi ng the w ar r anties of m er chantability and
fitness for particular purpos e, ar e l im i ted to the appli cabl e w ar r anty
period set forth above.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, or l i m i tati ons on how long an implied warranty
lasts, so the above exclusions or limitations may not apply to you.

PRECAUTIONS

MC352 /MC352-29

About this manual

5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support : 1-866-446-3595 / 813-888-9555

A. Re m oving the screw on the upper case by using

L-wrench.

B. Se par at e the uppe r c as e from the bottom ca se
C. Make the 4 mounting screw hol e on the ceiling/wall by drawing the

positions using the botto m c as e

D. PutPowercable andVideocable intotheceiling/wall.

E. Align the bottom case to the ceiling/wall by using

the screws.

F. Adjust the camera to its position

(Referance - "CAMERA SETTING" )

G. Connect the upper case and bottom case.
H. Tighten the Stop Screw t o the upper case using L- wrench.

E

D

C

B

A

F

Before installing and using the c am er a, pleas e r ead thi s manual
carefully. Be sure to keep it handy for l ater reference.

TROUBLESHOOTING

Before sending the camera out for repai r , c heck the i tem s below . I f the
problem persists after checking these items, contact your service
center.

■ If no image appears.

Is the coaxial cable attached secur ely ?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (wi th the level vol um e) ?
Is there adequate illumination?

■ If the image is unclear

Is the lens in focus?
Is the lens dirty?
Dirt of fingerprints on the lens can adversel y affect the
images. Gently wipe any dirt or fingerprints off the lens
with a soft cloth or lens cleaning paper and cl eani ng
fluid (commercially available).
Is the monitor adjusted correctly?

WARNING:
TO PREVENT THE RISK OF FIRE O R ELECT RIC
SHOCK, DO NOT EXPOSE THI S A PPLI A NCE T O
RAIN OR MOISTURE.

■ Do not open or modify
Do not open the cabinet exit during maintenance and
installation, as it may be dangerous and cause damages.

■ Do not put objects insi de the uni t
Make sure that no metal objects or flammable substances get inside
the camera. It could cause fire, short- ci r c uits or damages.

■ Be careful when handling the unit
To prevent damage, do not drop the camer a or subjec t
it to strong shock or vibration.

■ Install away from el ectr i c or magneti c fiel ds

■ Protect from humi dity and dust

■ Protect from high temper atur e

Be careful when installing close to the ceiling , i n a kitchen or boiler
room, as the temperature may raise to high levels.

■ Cleaning
Dirt can be removed from the cabinet onl y by wi pi ng it
with a soft cloth moistened with a soft deter gent solution.

■ Mounting Surface
The mounting surface material must be strong enough to secure the
camera.

INSTALLATION

WARRANTY INFORMATION

Digital Watchdog (referred to as “the Warrantor”) warrants the

Camera Series against defects in materials or workmanship as follows:
LABOR: For the initial five (5) years from the date of ori gi nal pur c hase,
if the camera is determined to be defective, the Warrantor will repair or
replace the unit, with
new or refurbished product at its option, at no charge.
PARTS: In addition, the Warrantor will supply r epl acem ent par ts for the
initial five (5) years. To obtain war r anty or out of w ar r anty serv ic e,
please contact a Technical Support Representative at 1-866-446-3595
Monday through Friday from 9:00 AM to 5:00 PM Eastern.
A purchase receipt or other proof of the date of the or i gi nal pur c hase is
required before warranty service is rendered. This warranty only
covers failures due to defects i n mater ial s and wor k m anshi p w hic h
arise during normal use. Thi s war r anty does not cov er dam age w hic h
occurs in shipment or failures which are caused by products not
supplied by the Warrantor or failur es which result from accident,
misuse, abuse, neglect, mishandling, mis applicati on, alter ation,
modification, faulty installation, set- up adjustm ents, im proper antenna,
inadequate signal pick up, m al adjus tm ent of c onsum er contr ol s ,
improper operation, power l ine s ur ge, i m pr oper v ol tage s uppl y,
lightning damage, rental us e of the pr oduct or serv i ce by anyone other
than an authorized repair facility or damage that is attributable to acts
of God.

This warranty gives you specific l egal r i ghts and you m ay al s o have
other rights that vary from state to state.
If the problem is not handled to your satisfacti on, then write to the
Address above.

Service calls which do not involv e defective materials or workmanship
as determined by the Warrantor, in its sole discretion, are not covered.
Costs of such service calls are the r espons i bility of the purchaser.

LIMITS AND EXCLUSIONS

There are no express warranti es ex cept as listed above. The Warrantor
will not be liable for incidental or consequential damages (including,
without limitation, damage to r ecor di ng m edi a) resul ti ng from the use of
these products, or arising out of any br each of the w ar r anty. All expres s
and implied warranties, i ncl udi ng the w ar r anties of m er chantability and
fitness for particular purpos e, ar e l im i ted to the appli cabl e w ar r anty
period set forth above.
Some states do not allow the exclusion or limitation of incidental or
consequential damages, or l i m i tati ons on how long an implied warranty
lasts, so the above exclusions or limitations may not apply to you.

PRECAUTIONS

MC352 /MC352-29

About this manual

5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support : 1-866-446-3595 / 813-888-9555

A. Re m oving the screw on the upper case by using

L-wrench.

B. Se par at e the uppe r c as e from the bottom ca se
C. Make the 4 mounting screw hol e on the ceiling/wall by drawing the

positions using the botto m c as e

D. PutPowercable andVideocable intotheceiling/wall.

E. Align the bottom case to the ceiling/wall by using

the screws.

F. Adjust the camera to its position

(Referance - "CAMERA SETTING" )

G. Connect the upper case and bottom case.
H. Tighten the Stop Screw t o the upper case using L- wrench.

E

D

C

B

A

F

■ CONNECTIONS ■ LENS ADJUSTMENTS

■ CAMERA SETTINGS

(Uppe Case & Bottom Case )

CONNECTIONS AND CAMERA SETTINGS

CAUTION

Check for polarity when using a DC 12V power suppl y .

Adjust the panning(360˚) and tilt(41˚) position.

DIMENSIONS

CONNECTIONS AND CAMERA SETTINGS

CAUTION

Check for polarity when using a DC 12V power suppl y .

Adjust the panning(360˚) and tilt(41˚) position.

Camera Position Adjustment :

(1)Loosen the Screw(B) on the upper case by using L-W renc h(A) .
(2)Separate BOTTOM CASE(E) from UPPER CASE(C) by turnin g UPPER CASE(C) to the

right.

(3)Separate CLEAR DOME(D) from BOTT O M CASE(E).
(4)Fixing the camera position in BOTTOM CASE(E).
(5)Assemble CLEAR DOME(D) and UPPER CASE(C) with BOTTOM CASE(E)
(6)Tightening Screw(B) on the Upper case(C) by using L-Wrench(A).

DIMENSIONS

A

B

C

D

E