B3252DIR Series
About manual
INSTRUCTION MANUAL
5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support : 1-866-446-3595 / 813-888-9555
Before installing and using the camera, please read this
manual carefully.
Be sure to keep it handy for future reference.
5436 W Crenshaw Street
Tampa, FL 33634
www.digital-watchdog.com
Technical Support : 1-866-446-3595 / 813-888-9555
Before installing and using the camera, please read this
manual carefully.
Be sure to keep it handy for future reference.
PRECAUTIONS
■ Do not open or modify
Do not open the case except during maintenance and installation,
as it may be dangerous and cause damages.
■ Do not put objects inside the unit
Make sure that no metal objects or flammable substances
get inside the camera. It could cause fire, short-circuits or damages.
■ Be careful when handling the unit
To prevent damage, do not drop the camera or subject it to
strong shock or vibration.
■ Install away from electric or magnetic fields
■ Protect from humidity and dust
■ Protect from high temperature
Be careful when installing close to the ceiling , in a kitchen or boiler
room, as the temperature may rise to high levels.
■ Cleaning
Dirt can be removed from the case only by wiping it with a soft cloth
moistened with a soft deter
g
ent solution.
■ Do not open or modify
Do not open the case except during maintenance and installation,
as it may be dangerous and cause damages.
■ Do not put objects inside the unit
Make sure that no metal objects or flammable substances
get inside the camera. It could cause fire, short-circuits or damages.
■ Be careful when handling the unit
To prevent damage, do not drop the camera or subject it to
strong shock or vibration.
■ Install away from electric or magnetic fields
■ Protect from humidity and dust
■ Protect from high temperature
Be careful when installing close to the ceiling , in a kitchen or boiler
room, as the temperature may rise to high levels.
■ Cleaning
Dirt can be removed from the case only by wiping it with a soft cloth
moistened with a soft detergent solution.
■ Mounting Surface
The mounting surface material must be strong enough to support
the camera.
TROUBLESHOOTING
Before sending the camera out for repair, check the items below.
If the problem persists after checking these items, contact technical support.
■ If no image appears
Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (with the level volume) ?
Is there adequate illumination?
■ If the image is unclear
Is the lens in focus?
Is the lens dirty?
Dirt or fingerprints on the lens can adversely affect the
images. Gently wipe any dirt or fingerprints off the lens
with a soft cloth or lens cleaning paper and cleaning
fluid (commercially available).
Is the monitor adjusted correctly?
Before sending the camera out for repair, check the items below.
If the problem persists after checking these items, contact technical support.
■ If no image appears
Is the coaxial cable attached securely?
Are the power and voltage normal?
Has the iris of the lens inside the camera been
adjusted correctly (with the level volume) ?
Is there adequate illumination?
■ If the image is unclear
Is the lens in focus?
Is the lens dirty?
Dirt or fingerprints on the lens can adversely affect the
images. Gently wipe any dirt or fingerprints off the lens
with a soft cloth or lens cleaning paper and cleaning
fluid (commercially available).
Is the monitor adjusted correctly?
WARNING:
TO PREVENT THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT
EXPOSE
THIS APPLIANCE TO RAIN OR MOISTURE.
DIMENSION (mm)
INSTALLATION
G
F
C
B
A. Drill the holes in the places where the
screw holes of the Bracket are to be
mounted.
B. Using Screws, mount the Bracket to the
wall.
C. Assemble the Camera with the Bracket.
D. Loosen the Fixed Screw to adjust the
direction of the Camera.
E. After the Camera is adjusted firmly in
position, tighten the Fixed Screw to set of
the Camera.
F. Loosen the Screw on top of the Sun
G
F
C
B
A
D
A. Drill the holes in the places where the
screw holes of the Bracket are to be
mounted.
B. Using Screws, mount the Bracket to the
wall.
C. Assemble the Camera with the Bracket.
D. Loosen the Fixed Screw to adjust the
direction of the Camera.
E. After the Camera is adjusted firmly in
position, tighten the Fixed Screw to set of
the Camera.
F. Loosen the Screw on top of the Sun
Cover to adjust the Sun Cover.
G. If the image on the monitor looks good,
tighten the Screw to the Sun Cover.
CONNECTION
CAUTION :
Check for polarity when using a DC 12V power supply.
WARRANTY INFORMATION
Digital Watchdog (referred to as “the Warrantor” ) warrants the Camera
Series against defects in materials or workmanship as follows:
LABOR: For the initial fiv e (5) y ears from the date of original purchase, if the
camera is determined to be defective, the Warrantor will repair or replace the
unit, with
new or refurbished product at its option, at no charge.
PARTS: In addition, the Warrantor will supply replacement parts for the initial
five (5) years.
To obtain warranty or out of warranty service, please contact a Technical
Support Representative at 1-866-446-3595 Monday through Friday from 9:00
AM to 5:00 PM Eastern.
A purchase receipt or other proof of the date of the original purchase is
required before warranty service is rendered. This warranty only covers
failures due to defects in materials and workmanship which arise during
normal use. This warranty does not cover damage which occurs in shipment
Digital Watchdog (referred to as “the Warrantor” ) warrants the Camera
Series against defects in materials or workmanship as follows:
LABOR: For the initial fiv e (5) y ears from the date of original purchase, if the
camera is determined to be defective, the Warrantor will repair or replace the
unit, with
new or refurbished product at its option, at no charge.
PARTS: In addition, the Warrantor will supply replacement parts for the initial
five (5) years.
To obtain warranty or out of warranty service, please contact a Technical
Support Representative at 1-866-446-3595 Monday through Friday from 9:00
AM to 5:00 PM Eastern.
A purchase receipt or other proof of the date of the original purchase is
required before warranty service is rendered. This warranty only covers
failures due to defects in materials and workmanship which arise during
normal use. This warranty does not cover damage which occurs in shipment
or failures which are caused by products not supplied by the Warrantor or
failures which result from accident, misuse, abuse, neglect, mishandling,
misapplication, alteration, modification, faulty installation, set-up
adjustments, improper antenna, inadequate signal pickup, maladjustment of
consumer controls, improper operation, power line surge, improper voltage
supply, lightning damage, rental use of the product or service by anyone
other than an authorized repair facility or damage that is attributable to acts
of God.
LIMITS AND EXCLUSIONS
There are no express warranties except as listed above. The Warrantor will not
be liable for incidental or consequential damages (including, without limitation,
damage to recording media) resulting from the use of these products, or arising
out of any breach of the warranty. All express and implied warranties, including
the warranties of merchantability and fitness for particular purpose, are limited to
the applicable warranty period set forth above.
Some states do not allow the exclusion or limitation of incidental or
consequential
damages, or limitations on how long an implied warranty lasts, so the above
exclusions or limitations may not apply to you. This warranty gives you specific
legal rights and you may also have other rights that vary from state to state.
If the problem is not handled to your satisfaction, then write to the Address
above.
LIMITS AND EXCLUSIONS
There are no express warranties except as listed above. The Warrantor will not
be liable for incidental or consequential damages (including, without limitation,
damage to recording media) resulting from the use of these products, or arising
out of any breach of the warranty. All express and implied warranties, including
the warranties of merchantability and fitness for particular purpose, are limited to
the applicable warranty period set forth above.
Some states do not allow the exclusion or limitation of incidental or
consequential
damages, or limitations on how long an implied warranty lasts, so the above
exclusions or limitations may not apply to you. This warranty gives you specific
legal rights and you may also have other rights that vary from state to state.
If the problem is not handled to your satisfaction, then write to the Address
above.
Service calls which do not involve defective materials or workmanship as
determined by the Warrantor, in its sole discretion, are not covered. Costs of
such service calls are the responsibility of the purchaser.
Model no.
B3252DIR
Camera TYPE Color/BW 12IR LED Day/Night Digital Bullet Camera
Mount Conventional Bracket
Image Device Samsung HAD CCD
Size 1/3"
Pixels-Total 537(H) x 505(V)
Pixels-Effective 510(H) x 492(V)
Scanning System 525 line, 2:1Interlace
Horizontal Frequency Internal Mode 15,734Hz
Vertical Frequency Internal Mode 59.94Hz
Min. Scene Illumination IR-LED on 0 Lux
Functions WDR ON
AGC ON/OFF (Gain Adjust)
AWB ATW / AWB / Manual
Lens Focal Length 3.6mm
Resolution Horizontal 420 TV Lines
Video Output VBS 1.0Vp-p VBS 1.0Vp-p(75 Load)
S/N Ratio S/N Ratio 48dB
OSD OSD NO
Environmental Conditions Operating Temperature
-10℃ ~ +55℃(14℉ ~ 131℉)
Humidity Less than 90%
Power Power Requirement 12VDC
Power Consumption 12VDC: 86mA(LED OFF) 215mA(LED ON)
Physical Specification Dimensions(W x H) 110 x 64.7mm
Loading...