Digital Voice Research NRGSUB 800 User Manual
COMPACT ACTIVE SUBWOOFER
800 W RMS MOSFET POWER AMPLIFIER
ELECTRONIC STEREO CROSSOVER
AUDIO PROCESSOR
ELECTRONIC LIMITER
NN
NN
RR
RR
GG
GG
SS
SS
UU
UU
BB
BB
88
88
00
00
00
00
USER’S MANUAL
GB
DESCRIPTION
The NRGSUB 800
is a very compact and innovative
subwoofer
that can ensure an absolute
sound quality in any use conditions.
It incorporates a powerful and reliable 800 Wrms power amplifier with MOS-FET technology designed for making a dynamic and clear sound, along with a music quality without equal.
The dynamics of trasducer is maximized by the AUDIO SIGNAL PROCESSOR and the ELEC-
TRONIC LIMITER and it at the same time protected from signal peaks and distorsion wich
could compromise its lenght.
Thanks to the trasducers quality, the high technological content of its incorporated power
amplifier, the
NRGSUB 800
meet the strict demand of PA system as bass frequency reinforce-
ment system.
On the top of the cabinet there is a top hat on which insert a standard stand for acoustic speaker.
USE OF BALANCED INPUTS
NRGSUB 800
inputs are BALANCED 3 poles XLR CANNON type.
Balanced connection is studied to have a better rejection against the noise that wires (if very long)
takes from external interferences.
Most of professional audio equipment have balanced outputs, you can use however non balanced
connection with mono JACK (or 3 poles CANNON with pin 3 connected to pin 1) the NRGSUB
800 will work normally, but it will be more sensitive to external interferences.
LINK outputs are paralleled with inputs, so they are balanced/sbalanced like the inputs.
XOVER outputs are always BALANCED type.
USE OF CROSSOVER AND
LINK / XOVER OUPUTS
Internal crossover can be utilized in STEREO mode; connecting the two inputs L - R and their outputs, or in MONO mode; connecting only the R (MONO) input and its relative outputs (see fig.1).
The crossover outputs can be LINK or XOVER types;
• LINK OUTPUT is nothing else that the paralleled input signal, it can be used to give the save signal
to another speaker system.
It can be used to have a reinforcement on bass frequency, the speaker system connected to the
LINK output will reproduce the full range of frequency. If the speaker system does not can handle
bass frequency or you hear dangerous distorsions, is preferred to use XOVER output.
• XOVER OUTPUT allows to exclude from the output signal all bass frequency range (< 125 Hz).
It can be used to have the best sound clearness and an higher sound pressure in the mid/high frequency. The sound system connected to the XOVER ouput will reproduce only the mid/high frequency range (> 125 Hz).
To have an higher sound pressure in bass frequency, is preferred to use LINK output.
USE OF INPUTS LEVEL
Volume knob adjust the input level of the two inputs and control only the subwoofer level,
the
volume of LINK and XOVER outputs are unchanged.
Is preferred to use this control to have the right compromise between the bass frequency generated from subwoofer and the rest of sound system.
The sound level can vary, it depend of the type of sound systems and connections (balanced/sbalanced - link/xover).
The internal electronic limiter will always protect the loudspeaker and the amplifier from dangerous
input signal levels.
USE OF KEY GND-LIFT:
Switch for the electrical separation between the ground circuit and the earth circuit; in the
“ ” position, the input signal ground is electrically disconnected from the earth circuit, in the
event the speaker develops a buzz, this position provides for opening the “ground rings,” that
are often the cause of such interference. In the “ ” position,
the input signal ground is electrically connected to the device's earth circuit.
USE THE GROUND LIFT FOR BALANCED SIGNALS ONLY.
Loading...