Page 1
Specification Sheet
M-Vision Laser 16K WUXGA
14,200 ANSI / 16,000 ISO Lumens | Contrast Ratio: 10,000:1 (Dynamic Black) | Part No:118-770
Colour System: DMD Specification:
Blue Laser Phosphor + 4-segment colour wheel
Display Type:
1 x 0.96" DarkChip™ DMD™
1920 x 1200 pixels native.
Fast transit pixels for smooth greyscale and improved contrast.
Aspect Ratio:
16x10
Fill Factor
87%
Key Features
Video & Graphics Processing
HDMI 1.4b for Side by Side, Frame Packing, Frame Sequential & TopBottom 3D Formats.
Dual Flash Processing can be used to multiply the displayed frame rate for 3D sources.
Dual Pipe Processing: Two sources in parallel for Left and Right eyes.
Synchronisation of active glasses.
3G-SDI with loop-through.
24p and 1080p native display.
Geometry Correction
Cornerstone, Vertical & Horizontal Keystone, Pincushion & Barrel, and Image Rotation.
Blanking control for custom input window sizing.
Scaling for fixed aspect ratio screens.
Edge Blending
Correction for non-active pixels at the edge of the display.
Picture in Picture
Two sources can be displayed either one within the other (PIP) , or side by side, with the original aspect ratios
maintained.
HDBaseT® Interface
Built in support for transmission of uncompressed High Definition Video over standard CAT5e/6 LAN cable.
Allows the projector to be placed up to 100m from source with low cost cabling.
Colour Processing
Powerful seven-point colour correction for accurate colour matching.
Projector Controller Software
Intuitive user interface for network control.
Simultaneous control of user-defined groups of projectors.
At-a-glance monitoring of projector status.
Projector Automation
Real-time clock provides daily on/off automation.
Installation
Eye bolts included for easy rigging.
Source Compatibility:
Page 2
3GSDI is SMPTE 292M, SMPTE 259M-C and SMPTE 424M compliant.
HDMI including Deep Color™ processing.
Graphics standards up to 1920 x 1200 resolution at 60Hz via HDMI or DisplayPort.
Inputs/Outputs
Video & Computer
Type Connector Qty
DisplayPort 1.1a
HDMI 1.4a
3G-SDI in
3G-SDI out
HDBaseT (see LAN)
DisplayPort
HDMI
BNC
BNC
LAN RJ45
2
2
1
1
1
Communication & Control
Type Connector Qty
3D Sync Out
3D Sync In
LAN
RS232
Wired Remote
12V Trigger
NOTE: The HDBaseT and
LAN ports are not shared.
3D Formats Supported HDTV Formats Supported
Frame Packing
Dual Pipe
1080p (24Hz, 25Hz, 30Hz, 50Hz, 60Hz), 1080i (50Hz,
60Hz), 720p (50Hz, 60Hz)
Frame Sequential
Side By Side (half)
Top and Bottom
Computer Compatibility Bandwidth
Up to 1920 x 1200 165 MHz on analog RGB
165 Megapixels per second on HDMI
Remote Control Automation Control
Addressable IR Remote Control, wireless and wired
On-Board keypad
Crestron RoomView® Connected
PJLink Class 1
LAN
RS232
AMX (Device Discovery)
Served web page
Colour Temperature
3200K to 9300K
Lamp Type Typical Lamp Life
Laser Light Source 20,000 hours
BNC
BNC
RJ45
9-pin D-Sub
3.5mm Stereo
Jack
3.5mm Stereo
Jack
1
1
1
1
1
2
Lenses
Lens Part No. Focus Range Lens Shift
0.84 - 1.03 : 1 zoom
1.20 - 1.56 : 1 zoom
1.50 - 2.00 : 1 zoom
2.00 - 4.00 : 1 zoom
4.00 - 7.00 : 1 zoom
114-313
117-573
118-578
118-588
117-463
1.5m - 10m
1m - 8m
2m - 12m
2.5m - 15m
4m - 42m
Vert: 0.37 (U) 0.37 (D) frame, Hor: 0.12 (L) 0.12 (R) frame
Vert: 0.5 (U) 0.5 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Vert: 0.5 (U) 0.3 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Vert: 0.5 (U) 0.3 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Vert: 0.5 (U) 0.3 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Lens Mount
Motorised and programmable shift, zoom and focus.
Mechanical Mounting Orientation
Front/Rear Table
Front/Rear Ceiling
Adjustable Front/Rear Feet
Table Top or Inverted: Yes
Pointing Up: Yes
Pointing Down: Yes
Roll (Portrait): Yes
Power Requirements Power Consumption
100 - 240VAC 50/60Hz single phase * Note that in 120V
operation, the projector will be at 65% brightness
Typical 2000W @ 240VAC in Normal mode
Typical 1200W @ 240VAC in ECO mode
Typical 1200W @ 110VAC in Normal mode
Typical 1000W @ 110VAC in ECO modeW
Thermal Dissipation Fan Noise
Page 3
Typical 4146 BTU/Hour @ 240VAC in Normal mode
Typical 3276 BTU/Hour @ 240VAC in ECO mode
Normal mode: 45 dBA max, 42 dBA typical
Eco mode: 42 dBA max, 39dBA typical
Typical 4334 BTU/Hour @ 110VAC in Normal mode
Typical 3412 BTU/Hour @ 110VAC in ECO mode
BTU/Hour
Operating/Storage Temperature Operating Humidity
Operating: 0 to 40C (32 to 104F)
Storage: -20 to 60C (-4 to 140F)
10% to 90% relative, non-condensing
Weight (Chassis Only) Dimensions
49 kg
108 lb
H: 24.8 cm W: 53.0 cm L: 69.5 cm
H: 9.8 in W: 20.9 in L: 27.4 in
Safety & EMC Regulations
UL/cUL, CB, CCC, FCC Class A , CE, RoHS 2
IEC EN 60825-1:2014 Class 1 Laser Product
IEC 60825-1:2007 Class 3R Laser Product
Image type unknown
http://www.digitalprojection.co.uk/digital-products/.jpg
IEC EN 62471-5:2015 Risk Group 3
*Dimensions included for reference only and are subject to change. Please download the full set of CAD files for this
display for more accurate information.
Downloads
PDF CAD Drawings
AUTOCAD Drawings
Specifications subject to change without notice. Digital Projection version: - ©2016 Digital Projection.
DLP®, Digital Light Processing™ and DMD are trademarks of Texas Instruments, Inc
DIGITAL PROJECTION, INC 55 CHASTAIN ROAD, SUITE 115 KENNESAW, GA. 30144
T: 770.420.1350 | F: 770.420.1360 | www.digitalprojection.com
DIGITAL PROJECTION, LTD GREENSIDE WAY, MIDDLETON MANCHESTER, UK. M24 1XX
T: +44.161.947.3300 | F: +44.161.684.7674 | www.digitalprojection.co.uk
DIGITAL PROJECTION, CHINA Rm A2006,ShaoYaoJu 101 North lane, Shi AO International Center, Chao Yang District, Beijing, 100029,PR
CHINA
T: +86.10.58239771 | F: +86 10 58239770
DIGITAL PROJECTION, ASIA 16 NEW INDUSTRIAL ROAD, #02-10 HUDSON TECHNOCENTRE SINGAPORE 536204
T: +65.6284.1138 | F: +65.6284.1238
User Guides
Important Information
Loading...