Specification Sheet
HIGHlite Laser II 3D
13,000 ANSI Lumens | Contrast Ratio: 2,000:1 (10,000:1 Dynamic) | Part No:116-330
Colour System: DMD Specification:
3-chip DLP®
Display Type:
3 x 0.67" DarkChip™ DMD™
1920 x 1200 pixels native.
Fast transit pixels for smooth greyscale and improved contrast.
Aspect Ratio:
16x10
Fill Factor
87%
Key Features
Video & Graphics Processing
HDMI 1.4 for Side by Side, Frame Packing & Top Bottom for 3D formats.
Dual Flash Processing can be used to multiply the displayed frame rate for 3D sources.
Dual Pipe Processing: Two sources in parallel for Left and Right Eyes.
Synchronisation of active glasses.
High bandwidth digital inputs.
3GSDI with loop-through.
The projector automatically detects interlaced video and implements 3:2 or 2:2 extraction as appropriate, with
pixel based, motion adaptive interpolation and auto cadence correction.
24p and 1080p native display.
Geometry Correction
Cornerstone, Vertical & Horizontal Keystone, Pincushion & Barrel, and Image Rotation.
Blanking control for custom input window sizing.
Edge Blending
Correction for non-active pixels at the edge of the display.
Electronic black level compensation.
HDBaseT® Interface
Built in support for transmission of uncompressed High Definition Video over standard CAT5e/6 LAN cable.
Allows projector to be placed up to 80m from source with low cost cabling.
ColorMax™
Accurate matching of projectors in tiled or blended applications.
User selection and storage of primary and secondary color targets.
Projector Control
Infra-red and wired remote.
LAN control via protocol.
Network control via hosted web page.
Built-in ON/OFF timer for automatic start and switch off.
Projector Controller Software
Intuitive user interface for network control.
Simultaneous control of user-defined groups of projectors.
At-a-glance monitoring of projector status.
Source Compatibility:
HDMI including Deep Color™ processing and 3D standards.
DisplayPort accepts graphics standards up to 1920 x 1200 at 120Hz.
3GSDI is SMPTE 292M, SMPTE 259M-C and SMPTE 424M compliant.
Graphics standards up to 1920 x 1200 resolution via DisplayPort, HDMI or VGA.
Component Video (SD and HD) via YPrPb or RGB.
Inputs/Outputs
Video & Computer
Type Connector Qty
HDMI 1.4
DisplayPort 1.1a
HDBaseT/LAN
3G-SDI In
3G-SDI Out
VGA
Component Video
HDMI
DisplayPort
RJ45
BNC
BNC
15-pin D-Sub
3 x BNC
2
1
1
1
1
1
1
Communication & Control
Type Connector Qty
3D Sync Out
3D Sync In
LAN (see HDBaseT)
RS232
Wired Remote
12V Trigger
Service Port
NOTE: The LAN port is
shared with HDBase-T.
3D Formats Supported HDTV Formats Supported
Frame Packing
Dual Pipe
Frame Sequential
1080p (23.98Hz, 24Hz, 25Hz, 29.97Hz, 30Hz, 50Hz,
59.94Hz, 60Hz), 1080i (50Hz, 59.94Hz, 60Hz), 720p
(50Hz, 59.94Hz, 60Hz)
Side By Side (half)
Top and Bottom
Computer Compatibility Bandwidth
Up to 1920 x 1200 170 MHz on analog RGB
165 Megapixels per second on HDMI
295 Megapixels per second on DisplayPort
Remote Control Automation Control
Addressable IR remote control, wireless and wired
On-Board keypad
LAN
RS232
Colour Temperature
User selectable from 3200 to 9300K
Lamp Type Typical Lamp Life
Laser Light Source 20,000 hours
BNC
BNC
RJ45
9-pin D Sub
3.5mm Stereo
Jack
3.5mm Stereo
Jack
USB Type A
1
1
1
1
1
2
1
Lenses
Lens Part No. Focus Range Lens Shift
0.77 : 1 fixed HB
1.16 : 1 fixed HB
1.45 - 1.74 : 1 zoom HB
1.74 - 2.17 : 1 zoom HB
2.17 - 2.90 : 1 zoom HB
2.90 - 4.34 : 1 zoom HB
4.34 - 6.76 : 1 zoom HB
110-808
110-809
110-803
112-878
113-852
110-806
110-807
1.3m - 15.0m
1.4m - 25.0m
1.8m - 9.3m
2.2m - 11.8m
2.7m - 15.4m
3.6m - 22.5m
5.5m - 35m
Vert: 0.2 (U) 0.2 (D) frame, Hor: 0.05 (L) 0.05 (R) frame
Vert: 0.2 (U) 0.2 (D) frame, Hor: 0.05 (L) 0.05 (R) frame
Vert: 0.6 (U) 0.6 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Vert: 0.6 (U) 0.6 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Vert: 0.6 (U) 0.6 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Vert: 0.6 (U) 0.6 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Vert: 0.6 (U) 0.6 (D) frame, Hor: 0.15 (L) 0.15 (R) frame
Lens Mount
Motorised shift, zoom and focus.
Mechanical Mounting Orientation
Front/Rear Table
Front/Rear Ceiling
Adjustable Front/Rear Feet
Table Top or Inverted: Yes
Pointing Up: Yes
Pointing Down: Yes
Roll (Portrait): Yes
Power Requirements Power Consumption
110 - 240VAC 50/60Hz single phase
1700W
At 110V the light output is up to 70% of full power.
Thermal Dissipation Fan Noise
5800 BTU/Hour 52 dBA
Operating/Storage Temperature Operating Humidity
Operating: 0 to 35C (32 to 95F)
Storage: -20 to 60C (-4 to 140F)
20% to 90% non-condensing
Weight (Chassis Only) Dimensions
55 kg
121.3 lb
H: 26.5 cm W: 58.5 cm L: 71.0 cm
H: 10.4 in W: 23.0 in L: 28.0 in
Safety & EMC Regulations
CE, FCC Class A , UL, CCC, KC, BIS
*Dimensions included for reference only and are subject to change. Please download the full set of CAD files for this
display for more accurate information.
Image type unknown
http://www.digitalprojection.co.uk/digital-products/images/hl-laser-mk2-cad.jpg
Downloads
PDF CAD Drawings
AUTOCAD Drawings
Specifications subject to change without notice. Digital Projection version: - ©2016 Digital Projection.
DLP®, Digital Light Processing™ and DMD are trademarks of Texas Instruments, Inc
DIGITAL PROJECTION, INC 55 CHASTAIN ROAD, SUITE 115 KENNESAW, GA. 30144
T: 770.420.1350 | F: 770.420.1360 | www.digitalprojection.com
DIGITAL PROJECTION, LTD GREENSIDE WAY, MIDDLETON MANCHESTER, UK. M24 1XX
T: +44.161.947.3300 | F: +44.161.684.7674 | www.digitalprojection.co.uk
DIGITAL PROJECTION, CHINA TOWER C, RM C1202, CAI FU JIA YUAN, NO. 19 XIA0 YING STREET, CHAOYANG DISTRICT BEIJING,
PR CHINA 100101
T: +86.10.58239771 | F: +86 10 58239770
User Guides
Important Information
DIGITAL PROJECTION, ASIA 16 NEW INDUSTRIAL ROAD, #02-10 HUDSON TECHNOCENTRE SINGAPORE 536204
T: +65.6284.1138 | F: +65.6284.1238
Loading...