DigitaLinx DL-DA12S, DL-DA14S Installation Manual

DL-DA12S Installation Guide

Included Accessories:

• Installation guide

• Power supply

• AC adapters (AU, EU, UK, and US)

• Rubber feet

• Mounting “L” brackets (2 ea)

• Mounting screws (4 ea)

The Digitalinx DL-DA12S is a one input to two output HDMI distribution
amplifier (DA). The DL-DA12S supports 3D and 4K video resolutions as
well as multichannel audio formats.

The EDID setting for the DL-DA12S is defined by the first detected
display. The DL-DA12S features diagnostic LEDs on the front of the
product indicating the state of the connections into and out of the
unit.

Diagnostic LEDs:

The DL-DA12S provides four LEDs to indicate the current operating status and to
assist troubleshooting an installation.

Power: Solid, the DL-DA12S is receiving power from the power supply.
Input: Flashes once per second, the input signal is not encrypted. Solid, the input

signal is encrypted. Not lit, no input signal is detected.
Out 1, Out 2: Solid, video is passed to an active display.

EDID Management:

The EDID setting for the DL-DA12S is defined by the first detected display.

For example, the display on Out 1 supports 4K video. When the source plays 4K
content, it will pass to all displays. If a display does not support the video content,
there will be no video output on the display.

Important notice:

• Do not attempt to disassemble or alter the extender housing. There are no user­serviceable parts inside the unit. Doing so will void your warranty.

• To minimize the possibility of equipment damage from electrostatic discharge (ESD), all
source and destination equipment must be powered off during installation.

• Do not connect the extender to a telecommunication outlet wired to unrelated
equipment. Doing so may damage the unit or any connected equipment. Ensure all connected
twisted pair cabling is straight-through (point-to-point).

• Allow proper ventilation to reduce the risk of thermal failure.

Firmware Port:

A separate document will provide usage instructions once a new firmware update is
available.