Digital Equipment DSP2022-S Installation Manual

DSP2022-S
SCSIDiskDrive
InstallationGuide

EK-2022S-IG-001

Digital Equipment Corporation

June, 1992

The information in this document is subject to change
without notice and should not be construed as a
commitment by Digital Equipment Corporation. Digital
Equipment Corporation assumes no responsibility for any
errors that may appear in this document.

Copyright © 1992 Digital Equipment Corporation

All Rights Reserved.
Printed in the U.S.A.

Contents

Scope of Information . ........... 1

Before You Begin . . . ........... 1

Locate the SCSI Connector ....... 2

Note Pin Status of the Vendor-Specific

Field . . . ................... 3

Note the Use of the SCSI Pin

Functions ................... 3

Locate Jumper Connector J1 . . . . . . 5

Learn the Jumper Functions ....... 6

Set the SCSI Device Address . . . . . . 7

Set the SCSI Address Remotely . . . . 8

Provide SCSI Bus Termination . . . . . 9

Obtain a Mounting Kit ........... 9

Locate the Drive Mounting Holes . . . . 9

Use the Drive Mounting Guidelines . . 11

Drive Specifications . ........... 12

iii

iv Contents

Figures

1 SCSI Connector ............... 2

2 Location of Jumper Connector J1 . . . 5

3 Side Mounting Holes . ........... 9

4 Bottom Mounting Holes .......... 10

Tables

1 Vendor-Specific Pin Options ....... 3

2 SCSI Pin Functions . ........... 4

3 Jumper Descriptions . ........... 6

4 Set SCSI Device Address ........ 7

5 Remote SCSI Address Determination . 8

6 Drive Specification Summary . . . . . . 12

DSP2022-S SCSI Disk Drive Installation Guide 1

Scope of Information

This guide supplies information needed to configure and
install your Model DSP2022-S 2.5-inch Small Computer
System Interface (SCSI) disk drive. The tasks you need
to perform are listed in order in the table of contents. The
specifications for the disk drive are found on the last page.

Before You Begin

Before removing the drive from its antistatic bag or
attempting installation, please read the following cautions:

ANTISTATIC CAUTION
As with any integrated circuit device, we highly
recommend that you use a properly grounded wrist
strap and antistatic pad when removing the disk drive
from its antistatic bag and handling it outside the bag.

HANDLING CAUTION
As with any delicate instrument, prevent shocks by
always placing it down gently. Avoid quick motions or
bumping.