![](/html/14/1493/14934da6606ecb517c348ea484a2e1198153823f916a0b4ff898bee746bdebd7/bg1.png)
DSP2022-A
ATA/IDEDiskDrive
InstallationGuide
EK-2022A-IG-001
Digital Equipment Corporation
![](/html/14/1493/14934da6606ecb517c348ea484a2e1198153823f916a0b4ff898bee746bdebd7/bg2.png)
June, 1992
The information in this document is subject to change
without notice and should not be construed as a
commitment by Digital Equipment Corporation. Digital
Equipment Corporation assumes no responsibility for any
errors that may appear in this document.
Copyright © 1992 Digital Equipment Corporation
All Rights Reserved.
Printed in the U.S.A.
![](/html/14/1493/14934da6606ecb517c348ea484a2e1198153823f916a0b4ff898bee746bdebd7/bg3.png)
Contents
Scope of Information . ........... 1
Before You Begin . . . ........... 1
Locate the ATA Connector ........ 2
Note Pin Status of the Vendor-Specific
Field . . . ................... 3
Note the Use of the ATA Signal Pins . 3
Locate Jumper Connector J1 . . . . . . 5
Learn the Jumper Functions ....... 6
Select Single or Dual Drive Operation 7
Remove Jumper 7 . . ........... 7
Obtain a mounting kit ........... 7
Locate the Drive Mounting Holes . . . . 8
Use the Drive Mounting Guidelines . . 10
Follow Connection Guidelines . . . . . . 10
Follow ATA Interface Instructions . . . . 10
Run the Setup Utility . ........... 11
Drive Specifications . ........... 12
iii
![](/html/14/1493/14934da6606ecb517c348ea484a2e1198153823f916a0b4ff898bee746bdebd7/bg4.png)
iv Contents
Figures
1 ATA Connector ............... 2
2 Location of Jumper Connector J1 . . . 5
3 Side Mounting Holes . ........... 8
4 Bottom Mounting Holes .......... 9
Tables
1 Vendor-Specific Pin Options ....... 3
2 Single-Ended ATA Signal Pins . . . . . 4
3 Jumper Descriptions . ........... 6
4 Default Setup Values ........... 11
5 Drive Specification Summary . . . . . . 12
![](/html/14/1493/14934da6606ecb517c348ea484a2e1198153823f916a0b4ff898bee746bdebd7/bg5.png)
DSP2022-A ATA/IDE Disk Drive Installation Guide 1
Scope of Information
This guide supplies the information you need to configure
and install your Model DSP2022-A 2.5-inch disk drive on
your PC AT Attachment (ATA) interface. The tasks you
need to perform are listed in order in the table of contents.
The specifications for the disk drive are found on the last
page.
Before You Begin
Before removing the drive from its antistatic bag or
attempting installation, please read the following cautions:
ANTISTATIC CAUTION
As with any integrated circuit device, we highly
recommend that you use a properly grounded wrist
strap and antistatic pad when removing the disk drive
from its antistatic bag and handling it outside the bag.
HANDLING CAUTION
As with any delicate instrument, prevent shocks by
always placing it down gently. Avoid quick motions or
bumping.