Digital Electronics Corporation PS345XA-HD40 Installation Manual
1
PS345XA-HD40
Installation Guide
The PS345XA-HD40 is the hard disk unit
(HDD unit) for Pro-face’s PS-3450A Series
(hereafter referred as the "PS-A") units and
PS3000-BA Series (hereafter referred as the
"PS-B") units. This 2.5 inch 40GB hard disk
is designed to be installed inside the PS-A/
PS-B unit.
Corresponding units:
PS-3450A/PS-3451A Series
PS3000-BA
About the Manual
For the detailed information on PS-A/PS-B
series, refer to the following manuals.
• PS-3450A Series Hardware Manual
• PS-3000B Series Hardware Manual
Manuals can be downloaded from Pro-face
Home Page.
URL
http://www.pro-face.com/otasuke/
Safety Cautions
• Be sure to check that the PS-A/PS-B
unit’s power is disconnected be fore
installing the unit, in order to prevent
an electrical shock.
• Do not attempt to modify or open the
HDD unit, since it can cause a shock or
fire.
• When installing the HDD unit, be sure
to read this guide "Installation" section's information completely to insure
that the unit is correctly installed.
To Prevent Accidents
• Since the HDD unit is a precision instrument, be sure it is neither hit by nor
pressed strongly against another object.
After unpacking, be sure the unit is not
dropped or jolted during installation. Also,
a PS-A/PS-B unit built in to a larger unit
(i.e. operation panel) should be removed
and packed separately prior to shipping.
• Be sure water, liquids or metal particles are
not allowed to enter the HDD unit. Any of
these may cause either a breakdown or an
electrical shock.
• Do not place or store this unit in a location
where there is direct sunlight, excessive
heat, dust or vibration.
• Do not store or operate this unit near chemicals, or where there are chemical fumes.
• Do not allow anyone other than Pro-face’s
own service staff to perform maintenance
or adjustments to this unit.
• Do not move or shift the PS-A/PS-B unit
while the HDD unit is installed and the PSA/PS-B unit's power is ON.
• Do not use the HDD unit in locations
where corrosive gasses are present, since
they can lead to a hard disk breakdown.
• T o prevent the data damage, be sure to shut
down the PS-A/PS-B unit’s OS according
to the correct procedure before turning
OFF the main power.
• To prevent HDD memory leaks, restart the
OS periodically.
• The hard disk has the lifetime. To use it
longer by steady operation, read the
attached “Instructions for Using the Hard
Disk” carefully.
• In order to extend the lifetime of the hard
disk, Pro-face recommends you set the
Windows
®
[Control panel]-[Performance
and Maintenance]-[Power Management
option]-[Turn off hard disks] selection to
turn the hard disk off when the unit is not
being operated. A setting of 5 minutes is
recommended.
2
Unit Disposal
• When this HDD unit is disposed of, it
should be done so according to your country’s regulations for similar types of industrial wastes.
Package Contents
(1) HDD Unit (1) (PS345XA-HD40)
(2) Attachment Screws (4)
(3) Jumper Plug (1)
(Attached to the HDD Unit)
(4) Installation Guide (1) (This Guide)
(5) Instructions for Using the Hard Disk (1)
Pro-face has taken the utmost care to ensure
the quality of this product when it was
shipped, however, should, for any reason,
problems or damage have occurred during
shipping, please contact your Pro-face
representative immediately for service.
3
Hardware Specifications
Features
• This HDD unit has a finite usage lifetime. Therefore, be sure to back up all HDD data
periodically and/or prepare a backup HDD unit.
• The HDD unit's lifetime will vary, depending on the usage conditions and environment.
The above value is calculated assuming an amb ient temperature of 20°C and 333
hours of operation per month. (HDD access frequency of 20% or less)
• To use the hard disk longer by steady operation, read the attached “Instructions for
Using the Hard Disk” carefully.
Environment
• Using the HDD unit in an environment that is excessively hot and/or humid will
shorten the disk’s usage lifetime. A wet bulb tem pe r ature of 29° C or less is reco mmended. This is equivalent to the following data.
Capacity 40GB
Average Seek T i me 12msec (TYP)
Power Consumption
At Startup : 5.0W (TYP)
Read/Write : 1.8/1.8W (TYP)
During Wait : 0.2W (TYP)
Interface PATA
Operation Lifetime 5 years, or 20,000 operating hours,whichever comes first
Weight Approx. 200g
Operating Temperature
PS-3450A
PS3000-BA
5°C to 50°C
PS-3451A 5°C to 45°C
Storage Temperature -20°C to +60°C
Ambient Humidity
10%RH to 90%RH (no condensation)
(Wet bulb temperature: 29°C or less)
Noise Resistance
(via Noise Simulator)
Noise Voltage: 1500Vp-p
Pulse Width: 50ns, 500ns, 1µs
Electrostatic Discharge 6kV
Vibration Resistance
4.9m/s
2
(10Hz to 25Hz) (When Operating)
Shock Resistance
3920m/s
2
(1ms, Half-sine shock pulse) (When Shipping)
Temperature at 35°C at 40°C
Humidity no higher than 64%RH no higher than 44%RH
Loading...