Digital Check BranchXpress BX7200 Easy Installation Manual

● Note: Digital Check does not provide the

required device drivers or scanning software.

Please contact your bank, IT department or
other solution provider for further assistance
with installing the driver or getting the scanning
software set up or installed.

Do not connect the USB cable from the scanner
to your PC before installing the drivers or the
scanning application / software.

www.digitalcheck.com

BranchXpress® BX7200 Easy Installation Guide

What’s Included Installing the Ink Cartridge Getting Started

▪ BranchXpress BX7200 scanner

● The label that is located on the bottom of the

scanner contains the exact model description.

● Open the ink cartridge package and remove
the protective seal.

● Insert the nozzle end of the cartridge into the
platform while keeping the end of the cartridge
tilted slightly upward. Push down on the rear of
the cartridge until it clicks twice and snaps
into position.

▪ USB 2.0 cable

▪ Power supply with electrical supply cord

▪ Ink cartridge

● The cartridge should appear tilted at a slight

angle when it is fully seated. Reinstall cover.

● Lift up on the ‘Camera 1 Cover’ to remove it
and provide access to the ‘Ink Cartridge
Platform’.

Rev 120712

● Turn off or disconnect other USB devices
such as USB printers or scanners. A mouse or
keyboard are okay to leave on or connected.
Note: This is only necessary when installing the
scanner driver or software the first time.

● When connecting the scanner, plug the power
supply into the scanner first, then into an outlet.

● Connect the USB cable to the PC after the
power cords and driver or software have been
successfully installed.

● Connect the scanner directly to an available
USB port on the PC.

● Place the scanner on level surface and 6-12
inches away from other electronic devices.

General Installation Tips Document Preparation Additional Information

● For detailed scanner information and tips for
performing routine maintenance, please see our
user manuals and training videos available at:

www.digitalcheck.com

● Scanner cleaning supplies and other
consumables and accessories can be
purchased directly from our online e-store.

● Remove any rubber bands, staples, paper

clips, straighten any bent corners etc.

Note: Digital Check recommends using our

MJ1000 Check Jogger to help align the edges

of large or frequent batches of documents.

● The leading and bottom edges of items

should be aligned. Place the item(s) by sliding

them into the ‘Entry Tray’ with the front of the

item facing out and away from the scanner.

Aligned items must be inserted flat into the

‘Entry Tray’ and slid forward until they stop or

are pulled into the scanner.

● Adjust the ‘Exit Tray’ by sliding it out to

accommodate business size checks.

Rev 120712

www.digitalcheck.com

BranchXpress® BX7200 Easy Installation Guide