Digi-Sense Temp-300, Temp-340, Temp-360 Instruction Manual

68X526701 | Rev 1 | Sept 09

Temp 300 / 340 / 360

USB Communication Driver Manual

About Temp 300, Temp 340 and Temp 360

The Temp 300, 340 and 360 thermometers feature real-time dat alogging and a USB dat a output for ea sy data transfer from
thermometer to computer. The seven-button control panel and intuitive on-screen menus guide you in choosing your
desired functionality. Additional meter features include Min/Max, Hold, and average functions; °C/°F selection; time
stamp/clock; countdown timer; out-of-range alarm with visible indicator; auto-shutoff; and low-battery indicator.

This manual will guide you through:

1. Installation of the USB driver on your computer

2. Data transfer from meter to computer

Installing the USB Communication Driver for Temp 300 (Refer to page 4 if you are using Temp 340/ 360)

1. Insert the USB Communication Driver into the CDROM of your computer.

2. Connect your Temp 300 to your computer using the provided USB cable.

3. The computer will automatically detect the meter with a message “New Device Found”. It will then prompt for the
installation driver (figure 1). Select “Install from a list or specific location (Advanced)” and click “Next”:

Figure 1: The computer automatically prompts for installation driver

1

4. Select “Search for the best driver in these locations”. Check “Include this location in the search:”, then click
“Browse” to search for the driver within the CD Drive (figure 2). Click “Next” to continue.

Figure 2: Direct the installation wizard to the CD

5. The computer starts installing the driver (figure 3).

Figure 3: Driver installation in progress

2

6. A prompt appears at the end of the installation (figure 4). Click “Continue Anyway”.

Figure 4: Select “Continue Anyway”

7. Select “Finish” to close the wizard (figure 5):

Figure 5: Select “Finish” to complete installation

3

Installing the USB Communication Driver for Temp 340/ 360 (Refer to page 1 if you are using Temp 300)

1. Insert the USB Communication Driver into the CDROM of your computer.

2. Connect your Temp 340 or 360 to your computer using the provided USB cable.

3. The computer will automatically detect the meter with a message “Found New Hardware: TUSB3410 Boot Device”.
It will then launch the New Hardware Wizard (figure 6). Select “No, not this time”, and click “Next”.

Figure 6: The computer automatically launches the New Hardware Wizard

4. The New Hardware Wizard will prompt you for the driver CD. Select “Install from a list or specific location
(Advanced)” and click “Next” (figure 7).

Figure 7: The computer automatically prompts for installation driver

4