DIGI-SENSE DIGI-SENSE 94460-76 Manual

SPECIFICATIONS

Display: ½-inch high, triple display
Unit range: 23 to 122°F

(–5 to 50°C)
Probe range: –58 to 158°F

(–50 to 70°C)
Resolution: 1°
Accuracy: ±1°C
Sampling rate: 10 seconds
Features: Simultaneously displays ambient or

probe temperature and minimum
and maximum
temperature readings.

Prior to operation, remove the insulating tape
from the battery compartment.

PROBE

Sentry Thermometer has a detachable probe
sensor and 10 feet of cable. Plug the sensor
into the jack on the side of the unit.

With the probe sensor attached, Sentry
Thermometer simultaneously displays current
probe temperature and probe minimum/maxi­mum temperatures.

With the probe sensor removed, Sentry
Thermometer simultaneously displays current
ambient temperature and ambient minimum/
maximum temperatures.

NOTE: Press the RESET button once when­ever the probe sensor is removed or inserted.
Updated ambient or probe temperatures will
be displayed.

MOUNTING THE PROBE

A wire holder is provided
with the probe for perman­ent mounting. To mount the
probe, place a screw or nail
through the hole of the
wire holder and secure
the holder to the wall.
(See Fig. 1)

OPERATION

Fig. 1

Place the probe sensor in contact with the
liquid, air/gas, or semisolid to be monitored.
Display will update automatically.

Press the RESET button once to clear the
temperature memory and begin recording new
minimum and maximum temperatures.

ATTACHMENTS
Stand: The unit is supplied with a stand that is

an integral part of the thermometer. To stand
the unit on a table top, locate the stand on the
back of the unit and flip it out.

Wall mount: To hang the unit, flip the stand,
on the back of the unit, all the way up and affix
the hook to a nail or screw.

Magnet: A magnet is supplied with the unit.
Peel the protective paper off the adhesive tape
on the magnet. Press the magnet onto the
back of the thermometer and mount on any
metal surface.

VELCRO®: VELCRO® mounting strips are

supplied with the unit. Peel off the protective
backing. Adhere one strip to the unit and the
other to any clean, flat surface.

If this thermometer does not function properly for
any reason, please replace the battery with a new
high quality battery (see “Battery Replacement”
section). Low battery power can occasionally
cause any number of “apparent” operational
difficulties. Replacing the battery with a new fresh
battery will solve most difficulties.

BATTERY REPLACEMENT

Erratic readings, a faint display, no display, or
when all °C or °F digits flash are all indicators
that the batteries must be replaced. Using a
coin, unscrew the round battery cover. Remove
the exhausted battery and replace with a new

1.5 volt, G-13 size battery (Replacement Cat. No.

1039). With the rubber O-ring seated properly,
replace the battery cover.

99 Washington Street
Melrose, MA 02176

Phone [phone]
Toll Free 1-800-517-8431

Visit us at www.TestEquipmentDepot.com

©2014 92-4120-40 Rev 0 050614

TRACEABLE

SENTRY

THERMOMETER

INSTRUCTIONS

®