DIGI-SENSE DIGI-SENSE 94416-00 Manual

SPECIFICATIONS

Display: ¾” high 5-digit LCD
Timing capacity: 9 hr, 59 min, 59 sec
Resolution: 1 sec
Accuracy: 0.01%
Alarm: 1 min audible/visible
Size/Weight: 3 x 2½ x 1”, 2½ oz
Features: Count up/stopwatch timing, countdown

alarm timing, clock, 12/24 hour formats

CLEARING THE DISPLAY TO ZERO

Press CLEAR button to reset display to zero. In Timing
mode CLEAR operates only if the timer is stopped. If
the unit is timing, press START/STOP button to stop the
timer before clearing display.

CLOCK SETTING

1. Press and hold CLOCK button for 3 seconds. Bottom
left cursor blinks.

2. Press AM-PM button to select the proper setting.

3. Enter correct time (all six digits) using 0–9 buttons.

Example: If time is 4:46:18, press 0, 4, 4, 6, 1,

8. Clock is set once the last digit is entered. If an
incorrect time is entered, press CLEAR button to
clear the display.

4. Choose AM/PM or military time by pressing 12HR­24HR button located on back of unit.

COUNT-UP TIMING

1. Press COUNT-UP button (COUNT-UP appears on
display).

2. Press START/STOP button to begin count up.

3. Press START/STOP button again to stop count up
(see Time-Out section).

4. With count up stopped, press CLEAR button to return
the display to 0:00:00.

COUNTDOWN TIMING

1. Press TIMER button (TIMER appears on display).

2. If necessary, CLEAR the display.

3. Enter desired countdown time using buttons 0–9.

4. Press START/STOP button to begin countdown.

5. Press START/STOP button again to stop timing

(see Time-Out section).

6. When timer reaches 0:00:00, it alarms, the display

ashes and begins counting up to track elapsed time

since alarming.

7. When the alarm sounds, pressing the START/STOP
button silences the alarm, stops the count up, and
returns the display to the previously programmed
time. (Must be in Timer mode to halt count up and to
return display to the preset time.)
NOTE: Alarm sounds for 1 minute then stops auto­matically unless turned off manually. The count up
continues until turned off.

TIME-OUT

If a pause in the countdown or count-up timing operation
is required, press the start/stop button to “freeze” the
display at the current reading (time-out). To resume
timing at the point it was stopped, press the start/stop
button again. An unlimited number of time-outs may be
performed.

ALL OPERATIONAL DIFFICULTIES

If this timer does not function properly for any reason,
please replace the battery with a new high quality
battery (see Battery Replacement section). Low battery
power can occasionally cause any number of “appar-

ent” operational difculties. Replacing the battery with a
new fresh battery will solve most difculties.

BATTERY REPLACEMENT

A faint display, incorrect display, erratic display or
no display are all indicators that the battery must be
replaced. On back of unit, slide open the battery cover.
Remove the exhausted battery and replace with a
new AAA alkaline battery. For proper placement, see
drawing located inside battery compartment. Replace
battery cover.

©2017 92-7157-40 Rev. 0 072517

TRACEABLE

TRIPLE-PURPOSE

TIMER

INSTRUCTIONS

99 Washington Street
Melrose, MA 02176

Phone [phone]
Toll Free 1-800-517-8431

Visit us at www.TestEquipmentDepot.com

®