DIGI-SENSE DIGI-SENSE 90205-24 Manual

INSTALLATION
INSTRUCTIONS

Temperature as detected by built-in sensor
(i.e. room temp.)

Temperature as detected by the probe sensor
(i.e. water temp.)

1) Probe sensor:
Place the submersible
probe inside the tank
and press the suction
cup against the inner wall.
Choose a position which is less
affected by light or plant for more
reliable readout.

2) Unit: Remove the protective paper of the double-sided tape and press the unit against any clean
surface for mounting. Convenient position may be the outside wall of the tank.

OPERATING INSTRUCTIONS

1) Temperature readouts will display after battery is inserted.

2) Press MAX-MIN MEMORY button will display

Insert battery as indicated direction

maximum and minimum, readouts of room
temperature. Second press will display maximum
and minimum readouts of water temperature. Third
press, or after 8 seconds the display will show
current temperature readout.

3) If you press CLEAR after maximum or minimum temperature readout is recalled from the record,
you will start a new memory record and the old one is erased. Maximum/Minimum temperature
is the Highest/Lowest temperature readout as picked up from the accumulated temperature
readouts. Thus you can specify, HOURLY, DAILY, WEEKLY, MONTHLY Room/Water max-min
memory record by yourself.

99 Washington Street
Melrose, MA 02176

Phone [phone]
Toll Free 1-800-517-8431

Visit us at www.TestEquipmentDepot.com

©2014 92-4145-40 Rev. 0 060514

TRACEABLE

STICK

THERMOMETER

INSTRUCTIONS

®