DIGI-SENSE DIGI-SENSE 90205-03 Manual

SPECIFICATIONS
Range: –58 to 572°F / –50 to 300°C
Resolution: 0.1° from –20° to 200°
1° otherwise
Accuracy: ±1°C from –20 to 100°C
±0.4°C at tested points ±1°C otherwise
ULTRA™ THERMOMETER ACCURACY
OPERATION
1. Remove the protective sheath.
2. Press the ON/OFF button to turn the unit on.
3. Press the °F/°C button to toggle the display between displaying °F and °C.
4. Insert the stem of the thermometer into the material to be measured.
To use the protective sheath as a thermometer holder, slide the stem of the thermometer through the hole located at the end of the sheath.
5. Press the ON/OFF button to turn the unit off. To conserve battery life, always turn the unit off when not in use.
6. Replace the protective sheath.
ALL OPERATIONAL DIFFICULTIES
If this thermometer does not function properly for any reason, replace the battery with a new high­quality battery (see “Battery Replacement” sec­tion). Low battery power can occasionally cause
any number of “apparent” operational difculties.
Replacing the battery with a new fresh battery will
solve most difculties.
BATTERY REPLACEMENT
Erratic readings, a faint display, or no display, are all indicators that the battery must be replaced. Use a screwdriver to remove the battery cap by turning the cap counter-clockwise approximately 1/4 of a turn. Turning the cap further than 1/4 of a turn may damage the cap. Replace the exhausted battery with a new 1.5 volt, silver oxide, size 393 battery. Make certain the positive (+) side is visible. Replace the battery cap by turning the cap clock­wise approximately 1/4 of a turn. Turning the cap further than 1/4 of a turn may damage the cap.
99 Washington Street Melrose, MA 02176
Phone 781-665-1400 Toll Free 1-800-517-8431
Visit us at www.TestEquipmentDepot.com
©2015 92-4344-40 Rev. 1 032515
TRACEABLE
DIGITAL DIAL
THERMOMETER
INSTRUCTIONS
®
Loading...