Digi-Sense 98767-05 User manual

SPECIFICATIONS
Display:

3½ digit LCD, 0.7 inch (1.8 cm) high.

Range: 0.4 to 30.0 Meters per Second (m/s)

Accuracy: ±2% of the reading
Resolution: 1 Meter per Second (m/s)

Failsafe: Low battery indicator
Power: 9 volt alkaline battery

1.4 to 108.0 Kilometers per Hour (km/h)
80 to 5910 Feet per Minute (ft/min)

0.8 to 58.3 Knots (knots)

0.1 Kilometer per Hour (km/h)
10 Feet per Minute (ft/min)

0.1 Knots (knots)

FRONT PANEL QUICK REFERENCE
OFF/ON/HOLD - Turns power on/off to the unit. Sliding

the switch to the HOLD position
“freezes” the display.

m/s - Selects Meters per Second to be

displayed.

km/h - Selects Kilometers per Hour to be

displayed.

ft/min x 10 - Selects Feet per Minute to be

displayed.
Note: Multiply the reading displayed
by 10 to arrive at the actual value.
Ex. If the reading displayed is 40,
then the actual value is 400 Feet per
Minute.

knots - Selects Knots to be displayed.

OPERATION

Slide the OFF/ON/HOLD switch to ON to turn the unit on.
Slide the selector switch to the appropriate setting to
display the desired measurement. Place the anemometer

vane probe into the air ow and read the measurement

on the display. Note: Do not expose the anemometer
vane probe to liquid.

Slide the OFF/ON/HOLD switch to OFF to turn the unit
off. To conserve battery life, always turn the unit off when
not in use.

HOLD

Slide the OFF/ON/HOLD switch to HOLD to “freeze” the
display at the current reading. After the reading has been
recorded, slide the OFF/ON/HOLD switch to ON to return
to the current reading.

BENCH STAND

The unit is supplied with a bench stand that is built-in to
the back of the unit. To use the bench stand, locate the
second rectangular opening at the middle of the back of

the unit. Place your nger nail into the opening and ip

the stand out. To close the stand, simply snap it shut.

ALL OPERATIONAL DIFFICULTIES

If this anemometer does not function properly for any
reason, please replace the battery with a new high quality
battery (see “Battery Replacement” section). Low battery
power can occasionally cause any number of “apparent”

operational difculties. Replacing the battery with a new
fresh battery will solve most difculties.

Find Quality Products Online at: [e-mail]

www.GlobalTestSupply.com

BATTERY REPLACEMENT
BAT appearing on the bottom left corner of the display

indicates that the battery should be replaced. To replace
the battery, remove the battery cover screw located
on the back of the unit and slide the battery cover off.
Remove the exhausted battery and replace it with a new
9 volt alkaline battery. Replace the battery cover and
secure the battery cover screw.

TRACEABLE

DIGITAL

ANEMOMETER

INSTRUCTIONS

®

Find Quality Products Online at: [e-mail]

www.GlobalTestSupply.com