SPECIFICATIONS
Range: -100 to 199.9 °C
Resolution: 0.1°
Sensor: Pt 100 (Platinum)
Sampling Rate: 2 times/second
OPERATION
1. Attach the temperature probe to
the meter.
(The probe and meter connectors are keyed, do
not insert the connector incorrectly and force it.)
2. Slide the ON/OFF switch to ON to
turn the meter on.
3. Insert the probe into the material to
be measured and read the display.
Do not expose the display to temperatures
below -10 °C or above 45 °C as this may
damage the display.
The probe and cable may be exposed to
temperatures as low as -100 °C; however,
the probe cable may become brittle after
prolonged exposure to temperatures below
-50 °C. Bending a brittle cable may result
in damage to the cable. When exposed to
temperatures below -50 °C, wait for the cable
to reach ambient temperature before bending.
4. Slide the ON/OFF switch to OFF
to turn the meter off. To conserve
battery life, always turn the meter
off when not in use.
PROBE HOLDER
The probe holder allows
the probe to be
held in position
while attached to
beakers, stainless
steel cylinders,
vats, etc.. Pinch
the ends of the
holder and place
the probe through the outer hole in
the top portion of the holder and then
through the outer hole on the bottom
of the holder. When the ends of the
holder are released, the holder will
expand to grab the probe securely.
Use the clip to attach the holder to the
side wall of a container. To remove
the holder, pinch the ends of the
holder and remove the probe.
ALL OPERATIONAL DIFFICULTIES
If this thermometer does not function
properly for any reason, replace the
battery with a new high quality battery
(see the “Battery Replacement”
section). Low battery power can
occasionally cause any number of
³DSSDUHQW´RSHUDWLRQDOGLI¿FXOWLHV
Replacing the battery with a new fresh
EDWWHU\ZLOOVROYHPRVWGLI¿FXOWLHV
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
BATTERY REPLACEMENT
Erratic readings, a faint display, no
display or “LO BAT” appearing on the
display are all indications that the
battery must be replaced. Remove
the battery cover by sliding it in the
direction of the “open” arrows.
Remove the exhausted battery and
replace with a new 9 volt alkaline
battery. Replace the battery cover.
ACCESSORIES
Cat. No. 4138
Easy-Use Accessory Adaptor
Allows the unit to be run off AC power
for continuous use.
©2014 92-4230-40 Rev. 0 050514
TRACEABLE
-100° C
PLATINUM
FREEZER
THERMOMETER
INSTRUCTIONS
®
Find Quality Products Online at: sales@GlobalTestSupply.com
www.GlobalTestSupply.com
Loading...