DigiPower RF-6H34, RF-24H34, RF-12H34 User Manual
ACTION PACK 6, 12 & 24
HOUR RECHARGEABLE
BATTERY
High capacity power for GoPro Hero4, Hero3+ & Hero3
USER GUIDE
.Item No : RF-6H34, RF-12H34 , RF-24H34
2
ENGLISH
USING THE ACTION PACK IN 3 EASY STEPS
1. Open the GoPro housing so that the back is at a 90 degree angle to the camera body.
Pull straight down to remove it.
2.
3.
Attach the ACTION PACK to the case at a 90 degree angle to the camera
Close and latch the to the front body of the camera case.
1
2
3
ACTION PACK
Important note for Hero 3 users:
The waterproof housing for the Hero3 is larger than it is for the Hero3+/4. The waterproof housing from the
Hero3+/4 is required to use the Action Pack.
body. Gently snap it in place.
3
ENGLISH
Connect the micro USB cable from the ACTION PACK to the
USB wall charger. The LEDs (located on the back of the
CHARGING STATUS INDICATOR
STATUS DISPLAY STATE CHARGE STATUS
One LED is blinking Below 30%
One LED is on, next LED is blinking 30% - 65%
Two LEDs are on, last LED is blinking
66% - 99 %
All three LEDs are on 100%
CHARGING THE ACTION PACK
To check the charge level shake the ACTION PACK once.
When the ACTION PACK is fully charged the LEDs will
case) will turn on to indicate the pack is being charged.
4
ENGLISH
This battery has a built in shake switch, shake once to check the
BATTERY LEVEL INDICATOR
STATUS DISPLAY STATE BAT TERY LEVEL
One LED is on 5% - 32%
Two LEDs are on 33% - 66%
Three LEDs are on >66%
CHECKING THE BATTERY POWER LEVEL
When the pack is connected to the camera and the camera
is turned on the LEDs will remain lit to indicate the remaining
power level. When the pack runs out of power the last LED
Important note: For the most accurate reading of how much
power remains in the ACTION PACK do not reference the LCD
display on the camera. For remaining capacity check the LEDs
on the ACTION PACK.
One LED is blinking < 5% charge remaining
ENGLISH
5
Item No.
Battery
Capacity
Input
Charging
Battery
output
Approx. time
to fully charge
the battery
Dimensions
in inches
Dimensions in
millimeters
Weight
in ounces
Weight
in grams
RF-6H34 3200mAh 5V DC 1.0A 5V DC 3.5hrs 1.2x2.2x2.6 32x56x66 2.68 76
RF-12H34 4800mAh 5V DC 1.5A 5V DC 3.8hrs 1.4x2.2x2.6 35x56x66 3.77 107
RF-24H34 9600mAh 5V DC 1.5A 5V DC 7.5hrs 2.3x2.2x2.6 58x56x66 6.84 19
4
Please Note:
1. A Class 10 video card will provide the best performance and run times, a minimum of class 6 is required. Look for
a number inside the letter C on the front of the card.
2. Shooting at higher resolutions like 4K video will result in less run time because it uses more power.
3. The ActionPack can be used without the internal camera battery installed but if the internal battery is installed it
must have some charge or the camera will not turn on.
4. The ActionPack and the camera itself can get hot when used for long periods of time, use care when handling.
5. All models of the ACTION PACK have been tested and approved to IEC standard IP68 for water and dust
ingress. It is completely dust proof and is waterproof to depth of 40 meter for over 3 hours of continuous use.
6
ENGLISH
Visit:
www.re-fuel.com
for more information.
2015 Mizco International, Inc. Avenel, New Jersey.
All rights reserved.
tel: 800-838-3200
email: refuel@mizco.com
DigiPower is a registered trademark of
Mizco International, Inc.
For AC charger
if supplied
t Input: 100 - 240 V~0.5A 50/60Hz
t Output: 5V DC
…
2.1A
(Included in the RF-12H34 and RF-24H34 only)
Over current protection, over voltage protection,
short circuit protection.
t
Loading...