Digilent 240-065P User Manual

Fan

M3x.5 nut (x4)

.75" M3x.5 Nylon Standoff

(Two locations)

Top PlexiGlas Plate (9 screw holes)

Fan Bracket (x2)

M3x16 panhead
metal screw (x4)

Lock washer (x2)

Step 1: Fan

Assembly Detail

1.25" M3x.5 Nylon Standoff
(Five locations)

Assembly Instructions (Small Philips Screwdriver needed)

Step 1:

Attach fan to top Plexiglas plate using fan brackets (x2), M3x16 panhead
screws (x4), M3x.5 nuts (x4), and lock washers (x2) as shown.

Step 2:

Attach stand-offs to top Plexiglas plate using acrylic screws.

Step 3:

Plug FMCOMMS1 board into ML605 board. Attach Fan cable to J33
on ML605 board (near center of board, by FPGA/Fan).

Step 4:

Place top Plexiglas cover upside down on clean surface, and attach
FCOMMS/ML605 board to top plate.

Step 5:

Attach bottom Plexiglas plate.

Step 6:

Attach antennas, and attach rubber feet to bottom Plexiglas plate
near corners

Acrylic Screws

(14 locations)

FCOMMS1 Board

1" M3x.5 Nylon

Standoff

(Two locations)

ML605 Board

Bottom PlexiGlas Plate (7 screw holes)

0.5" M3x.5 Nylon Standoff

(Five locations)