Digigram PCX1222HR User Manual

D i g i g r a m

PCX1221HR

PCX1222HR

Professional Multichannel

Sound Cards

User’s manual

D i g i g r a m

2

For technical support,

please contact your system supplier

Digigram S.A.

Parc de Pré Milliet, 38330 Montbonnot - FRANCE

Tel: [phone]• Fax: [phone]• E-mail: [e-mail]

Digigram Inc.

2101 Wilson Boulevard, Suite 1004, Arlington, VA 22201-USA

Tel: [phone] • Fax: [phone] • E-mail: [e-mail]

Digigram Asia Pte Ltd.

350 Orchard Road - #19-07 Shaw House Singapore 238868-SINGAPORE

Tel: [phone] • Fax: [phone] • E-mail: [e-mail]

PCX1221HR & PCX1222HR

User’s Manual

3

Table of Contents

INFORMATION FOR THE USER

....................................................................................................4

IMPORTANT NOTICE

..............................................................................................................................4

CONTENTS OF THIS PACKAGE

.....................................................................................................5

FEATURES

...........................................................................................................................................................6

PCX1221HR main hardware features .........................................................................................................6

PCX1222HR main hardware features .........................................................................................................6

Main software features.....................................................................................................................................7

REQUIREMENTS

............................................................................................................................................7

Hardware requirements.................................................................................................................................... 7

Software requirements ...................................................................................................................................... 7

Supported operating systems...........................................................................................................................7

HARDWARE INSTALLATION

..........................................................................................................8

Installing the card ...............................................................................................................................................8

Interrupt and memory address .......................................................................................................................8

SOFTWARE INSTALLATION

..............................................................................................................8

Standard installation under Windows 2000, XP, and Windows Server 2003...................................8

Parameterizing the ASIO driver............................................................................................................. 10

Parameterizing the Wave driver........................................................................................................... 10

Removing the driver under Windows 2000, XP, and Windows Server 2003................................. 11

HOW TO CHECK THE INSTALLATION

................................................................................ 11

THE ‘DIGIGRAM HARDWARE SETTINGS’
(‘DHS’) CONTROL PANEL

................................................................................................................ 13

SPECIFICATIONS

....................................................................................................................................... 14

Configuration.............................................................................................................................................. 14

Inputs ........................................................................................................................................................... 14

Outputs........................................................................................................................................................ 15

Connectors.................................................................................................................................................. 15

Audio specifications .................................................................................................................................. 15

Audio Performance................................................................................................................................... 16

Development environments.................................................................................................................... 16

APPENDICES

................................................................................................................................................. 17

PCX1221HR Schematic Diagram........................................................................................................ 17

PCX1222HR Schematic Diagram........................................................................................................ 17

Layout .......................................................................................................................................................... 18

PCX1221HR cable diagram.................................................................................................................. 19

PCX1221HR wiring diagram................................................................................................................. 19

PCX1222HR cable diagram.................................................................................................................. 20

PCX1222HR wiring diagram................................................................................................................. 21

PCX1221HR cable pinout...................................................................................................................... 22

PCX1222HR cable pinout...................................................................................................................... 22

Copyright 2005 --- 2006 Digigram. All rights reserved.
No portion of this manual may be reproduced without prior written consent from Digigram. The copyright protection
claimed here includes photocopying, translation and/or reformatting of the information contained in this manual.
While every effort has been made to ensure accuracy, Digigram is not responsible for errors and omissions, and
reserves the right to make improvements or changes in the products and programs described without notice.
Digigram and the Digigram logo, PCX1222HR, and PCX1221HR are registered trademarks or trademarks of Digigram
S.A. Other trademarks are property of their respective holders.

D i g i g r a m

4

INFORMATION FOR THE USER

This device complies with part

15 of FCC rules. Operation is subject to the following

two conditions: (

1) This device may not cause harmful interference, and (2) This device

must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a CLASS B

digital device, pursuant to Part

15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions contained in this data sheet, may
cause harmful interference to radio and television communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
* reorient or relocate the receiving antenna
* increase the separation between the equipment and the receiver
* connect the equipment into an outlet on a circuit different from that of the receiver
* consult the dealer or an experienced audio television technician.

Note: Connecting this device to peripheral devices that do not comply with CLASS B
requirements or using an unshielded peripheral data cable could also result in
harmful interference to radio or television reception. The user is cautioned
that any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment. To ensure
that the use of this product does not contribute to interference, it is necessary to use
shielded I/O cables.

IMPORTANT NOTICE

This card has been tested and found to comply with the following standards:

• International: CISPR22 Class B

• Europe: EMC 89/336/CEE (1992) specifications

• United States: FCC Rules-Part 15-Class B (digital device)

In order to guarantee compliance with the above standards in an installation,
the following must be done:

• the provided cable must not be modified

• additional cables used must have their respective shield connected to

each extremity

PCX1221HR & PCX1222HR

User’s Manual

5

Warning:
Electrostatic discharge (ESD) can damage several

components on the board. To avoid such damage in
handling the board, take the following precautions:

Bring the device and everything that contacts it to
ground potential by providing a conductive surface and
discharge paths. As a minimum, observe these
precautions:

• Disconnect all power and signal sources.

• Place the device on a grounded conductive work surface.

• Ground yourself via a grounding wrist strap or by holding

a grounded object.

• Ground any tool that will contact the device.

CONTENTS OF THIS PACKAGE

Thank you for purchasing a Digigram PCX sound card.

The package consists of the following components:
* a PCX1222HR or PCX1221HR sound card

* the user’s manual at hand

The breakout cables to connect the card’s I/Os are not part of this package.
They are delivered separately.

Also available (optional):
2U 19-inch breakout box allowing straightforward and secure connection to

all the cards’ I/Os

D i g i g r a m

6

FEATURES

PCX1222HR and PCX1221HR are audio cards for PCI bus. They are
‘Universal PCI 64-bit/66 MHz’, which means they can be plugged in 32-bit/33
MHz 5 V PCI slots as well as in 64-bit/66 MHz 3.3 V keyed PCI slots. The
cards are also compatible with PCI-X interfaces.

PCX1221HR main hardware features

• 1 digital AES/EBU∗ stereo input, with hardware sample rate converter
(up to 96 kHz) and programmable digital gain

• 6 digital AES/EBU

∗

stereo outputs (up to 192 kHz) with programmable

digital gain

• 1 digital AES/EBU∗ stereo sync input (up to 192 kHz in play and record)

• 1 standard Word Clock input (up to 96 kHz)

• 1 standard Word Clock output (up to 96 kHz)

• 1 video sync input

• 1 SMPTE/LTC (Linear Time Code) sync input

PCX1222HR main hardware features

All features of the PCX1221HR, plus:

• 2 balanced

∗∗

analog mono line inputs, with software programmable

analog and digital gain

• 12 servo-balanced

∗∗∗

analog mono line outputs, with software

programmable analog and digital gain

• 192 kHz / 24-bit converters

• Maximum level on analog inputs and outputs: +24 dBu

Note: The digital outputs always play the digital version of the corresponding analog output.

The selection of the AES/EBU input excludes the selection of the analog inputs.

∗

can be used as S/PDIF interface as well

∗∗

can be used with unbalanced signals

∗∗∗

Electronically servo-balanced outputs provide automatic level adjustment to accommodate

either balanced or unbalanced lines

PCX1221HR & PCX1222HR

User’s Manual

7

Main software features

• Real-time, simultaneous record and playback in PCM (8, 16 and 24 bits)
as well as in MPEG Audio Layer I, Layer II and Layer III

L

, Float IEEE754

conversion supported (with 24-bit fixed-point dynamic range)

• When using the np SDK, real-time mixing of several PCM and MPEG
audio streams, direct monitoring, level adjustment, panning, cross-fades,
punch-in/punch-out, scrubbing, time-stretching, pitch-shifting, 3-band
parametric equalizer, maximizer, format and frequency conversions

• Low latency DirectSound, Wave, and ASIO drivers. Under DirectSound
and ASIO, the cards operate in PCM mode only (nevertheless, an
application can integrate coders/decoders on the host PC). Under Wave,
HR boards can operate in both PCM and MPEG (layer 1 and layer 2).

L

MPEG Layer III play-only on DSP;
MPEG Layer III recording on the host computer is available through
Digigram's PC Codec option using the np SDK

REQUIREMENTS

Minimum hardware requirements

• Pentium III minimum (or equivalent)

• 128 MB RAM

• One free PCI or PCI-X slot (5 V or 3.3 V)

Software requirements

To use your PCX1221HR or PCX1222HR, install the driver from the HR
Runtime package version 1.60 or higher. This package includes:

• a Digigram np driver enabling OEM applications to best capitalize

on the HR boards

• a WDM DirectSound driver. Microsoft DirectX 9 or higher must be

installed on your computer

• a Wave driver (installation optional).

• an ASIO driver (installation optional)

Supported operating systems

PCX1221HR and PCX1222HR cards run under Windows 2000, XP∗, and
Windows Server 2003

∗

.

∗

32-bit version