Digi Code 5010, 5012, 5020, 5022, 5190-01 Installation Instructions

Installation Instructions

Garage Door Opener Radio Controls

Model 5010 (300 mHz) \ 5012 (310 mHz) Single Button Transmitters

Model 5020 (300 mHz) \ 5022 (310 mHz) Dual Button Transmitters

Model 5190-01 (300 mHz) \ 5190-02 (310 mHz) Receivers

WARNING:

•• Disconnect operator power before any installation or repair

•• Always wear safety glasses

Your Digi-Code radio controls are designed specifically to remotely control a garage
door opener from within an automobile and to give years of trouble free service without
adjustment. Because all radio controls are set with the even numbered switches in the

“ON” position when they leave the factory, it is recommended that a different code
be selected and set at the time of installation. Please refer to the “Setting the Code

Switch” section for instructions. The radio frequency (RF) portion of the controls,
however, are tuned to standard frequencies and are thoroughly tested at the factory. This
permits the addition or replacement of either the transmitter or the receiver by specifying
the Model number and the RF frequency designated on the identification label. RF
adjustments are not needed nor should any be attempted.

RECEIVER INSTALLATION

The receiver is designed to mount directly to the operator. It can be remotely installed if
the operator terminal strip is not accessible, or if the power for the receiver is not
obtainable from the operator. To direct mount the receiver, simply loosen the terminal
screws on the operator and insert the two-way lugs from the receiver under the screw
heads along the wall button wires, and tighten the screws ( See Figure #1)

Place the antenna (a 10 inch black wire ) in a vertical position as far from any metal as
possible.

For remote installation the receiver may be mounted near the operator head on a joist or
the ceiling by using the mounting tab. Order Model 5192-06 adapter, which permits
connection between the operator terminal and the two-way lugs on the receiver.

Slip on connectors at one end of the adapter connect to the flat side of each spade lug on
the receiver, and the spade connectors at the other end connect to the operator terminal.