Page 1
Quick Start Guide
ConnectPort X2e ZB
Power Supply
Ethernet Cable
ConnectPort X2e ZB
1 Verify Contents
®
Ethernet
(1P):
90001297-88
B
4 Online Installation
Browse to
www.digi.com/X2EZB
and follow the instructions to download the Digi ESP™ for Python development environment
and the ConnectPort X2e ZB User’s Guide.
a
2 Write Down the Serial Number
Write down the following located on the back of the
ConnectPort X2e ZB :
Model: ConnectPort X2e ZB
Part Number: 50X2E-Z1C-001-01
Serial Number: 00409D50E9BB
Model: ConnectPort X2e ZB
Part Number: 50X2E-Z1C-001-01
Serial Number: 00409D 50E9BB
NOTE: The Serial Number is
also the Ethernet MAC
address.
Serial Number:
________________________________
3 Connect Hardware
Power
XBee
Network
Button
Internet router
a
Connect the Ethernet cable.
b
Connect the power supply.
c
Startup Sequence -
After plugging in the device, the
Power LED will turn solid green, and the Network LED
will gradually turn solid green if it can connect to iDigi.
NOTE: This product requires a DHCP server to
assign its IP address. If you do not have a DHCP
server, see the
ConnectPort X2e ZB User’s Guide
.
b
a
c
Page 2
© 2012 Digi International, Inc.
Digi, Digi International, Inc., ConnectPort, iDigi , and the Digi and iDigi logos are trademarks or registered trademarks of Digi International, Inc., in the United States and other countries worldwide. All other trademarks are the property of their respective owners.
Network LED
Description
Status
No power.
Solid green
Device is powered. This state does not indicate that the device is fully operational.
The Network LED and its states convey such information.
OFF
5 Troubleshooting
Power LED
Button - Holding the button for ten seconds returns the device to factory defaults.
Need Help? Call 1-877-693-7849 or visit www.digi.com/support.
For more information about this product, browse to
www.digi.com/X2EZB
Description
Status
Blinking yellow (slow) Operating system is running, but no Ethernet link is established.
OFF
Blinking yellow (fast)
Ethernet link is established, but no IP address is assigned to the gateway.
Solid yellow
An IP address has been assigned to the gateway.
Blinking green (slow)
Gateway is attempting a connection to an iDigi server.
Blinking green (fast)
iDigi server found and gateway is undergoing authentication.
Solid green
Gateway is connected to the iDigi server.
Alternating between
yellow and green
The gateway cannot connect to iDigi. The two most common reasons for
this state are:
- The gateway cannot connect to a DNS server to resolve the iDigi server address.
- The gateway cannot connect to an NTP time server to get the correct time.
See the iDigi User’s Guide’s Troubleshooting section to resolve this state.
Gateway operating system is not yet running.
Loading...