Digi 62533 User Manual

62533

Ethernet Adapter

INSTALLATION AND OPERATING

INSTRUCTIONS

For sales and Service in

North America contact:

ESD Systems.com

www.esdsystems.com

[e-mail]

Phone: [phone]

Fax: [phone]

TB-6128 Page 1 of 7 Revision 10/06

© 2005 DESCO INDUSTRIES INC.

Corporate Office:

3651 Walnut Avenue,

Chino, CA 91710

Phone: [phone]

Fax [phone]

For sales and service in Europe and

OK International - European Headquarters

Hampshire, SO53 4NF U.K. England

http://www.okintl.com/locations.htm

Asia contact:

Eagle Close, Chandlers Ford,

Tel: [phone]

Fax: [phone]

Employee Owned

Adapter, Ethernet 10/100 120VAC/220VAC

Installation and Operating Instructions

DESCRIPTION:

PACKAGING:

Power input: 100 ~ 240 VAC

• 1 Limit Comparator

Ethernet: 10/100 T-Base

• 2 Test Leads, Banana to

Communication: Serial

Figure 1.

Images are not actual size.

62533

TB-6128 Page 2 of 7 Revision 10/06

© 2005 DESCO INDUSTRIES INC.

Employee Owned

Packaging:

• 1 - Digi SP One Ethernet Adapter

• 1 - Diagnostic Loop Back Key

• 1 - Quick Start Guide

• 1 - Release Note

• 1 - Installation and Drivers CD-ROM

• 1 - 100 ~ 240 V to 12VDC Power Adapter

• 1 - 24” Inverted Communication Cable

• 1 - 4 pcs Universal Power Plugs

Note: Ethernet cable is not supplied with unit. End user must supply his or her own Ethernet cable.

System and Hardware Requirements:

• Designed to be used with Smartlog X3 systems

50440 - SmartLog X3 w/Dual Foot Plate, Keypad, & Barcode Reader, 120V
50441 - SmartLog X3 w/Dual Foot Plate, Keypad, & Barcode Reader, Euro Specs
50442 - SmartLog X3 w/Dual Foot Plate, Laser Scanner, Euro Specs, CE Approved

• Smartlog 6.03 software, TEAM Enterprise Software or TEAM Basic Software

Mounting and Installation:

NOTE: If existing model 50460 Ethernet adapter is used, model 50461 cannot be used on the same LAN due to
driver conflicts. We highly recommend switching over to model 50461 Ethernet adapter.

This technical bulletin is intended for personnel familiar with networking concept and Smartlog X3 systems.
Before mounting of the Ethernet adapter to wall or back-plate of Smartlog X3, Ethernet adapter unit must be, configure
with the correct communication parameter and be assigned an IP address.

1. Powering unit and Locating unit on the LAN

Make sure there is an Ethernet cable, LAN jack and power outlet for the Ethernet card to connect to.

Before powering or connecting Ethernet
cable, refer to Figure 2. dip switch must be
set to dip 1 to the on position (up) and the
rest off (switch 2 to 4 down, MFG default)
and the diagnostic loop back key must be
securely connected to serial (DB9 male)
port. Make sure the AC power adapter
supplied with model 50461 is used. The
AC power adapter is a 100 ~ 240VAC auto
switching power adapter and can be
plugged into any power outlet known with
the 4 piece universal plugs.

Figure 2.

TB-6128 Page 3 of 7 Revision 10/06

© 2005 DESCO INDUSTRIES INC.

Employee Owned