World Best Car Infomedia Systems
BSD Sensor User Manual
World Best Car Infomedia Systems
• BSD 란
- BSD (Blind Spot Detection) is a rear-side warning system that visually and audibly communicates the presence or absence
of a vehicle in a blind spot beyond the perceptible range of the driver to assist the driver in avoiding the risk of accident .
• BSD Sensor 장착 위치
- The following is described the BSD sensor location of the vehicle. It is located behind of the bumper.
Slave Sensor
Master Sensor
• BSD Sensor 작동 원리
- The following is described the basic BSD sensor operating method.
Detect
Warning level 1 : Lamp turn on
Warning level 2 : Lamp blink and sound
• Warning level
- Level 1 : When detect track able object at the blind spot area.
- Level 2 : When detect track able object and user switch the turn signal lever.
• BSD Sensor specification
- The following is described the specification of the BSD sensor.
World Best Car Infomedia Systems
• BSD RF Specification
World Best Car Infomedia Systems
• Detection Range
< BSD // Extended BSD(LCA) >
World Best Car Infomedia Systems
• Detection Range
< RCTA >
World Best Car Infomedia Systems
• Warning ON and OFF condition
< Warning ON >
< Warning OFF >
World Best Car Infomedia Systems
World Best Car Infomedia Systems
Notice:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Any changes or modifications not expressly approved by the party responsible for compliance could void the
authority to operate equipment.
Loading...