Diamond Press Marquise User Manual

USER GUIDE

Embossing and
die-cutting cannot
be done at the same
time. For die-cutting,
make sure to only use
blank folders with
cutting dies. Do not
place cutting dies in
an embossing folder
and pass through the
Diamond Press II tool.

1.

Place your Diamond Press II tool on a flat
surface that is both clean and smooth.

2.

Die-Cutting:

Put your die cut-side down on the paper
you are cutting and sandwich between
the BLANK folder.

OR

Embossing:

Sandwich your paper between the
EMBOSSING folder.

WARRANTY – Each Diamond Press tool comes with a limited one (1) year warranty against defects in product manufacturing workmanship and materials, under
normal residential use and specified conditions. The warranty shall be valid for a period of one (1) year starting from the date of original purchase. To receive a valid
warranty the customer must register their Diamond Press tool within sixty(60) days of the date of original purchase. Diamond Press reserves the right to repair or
replace the defective product at its own discretion. Should Diamond Press opt to furnish a replacement tool, Diamond Press agrees to provide either a replacement
product equal to the original purchase model, or a newer tool model. Shipping and handling fees for product return back to Diamond Press (including shipping,
handling, packing, return postage and insurance) are to be paid for by the customer in order for warranty to be claimed. Any claim for defective merchandise returns
must be packed in original packaging. The repaired tool or replacement tool will be shipped back to the customer at the expense of Diamond Press. Inserting paper,
or any other cutting or embossing materials, into the tool that are thicker than 300 GSM, 0.014 inches or 0.32 mm shall automatically void the warranty. Diamond
Press strongly advises that the customer only use certified Diamond Press brand die cutting and embossing products together with Diamond Press tools. Diamond
Press strongly advises against using any other brand of die cutting or embossing products in Diamond Press brand tools as most metal materials will not properly
pass through the tool and can cause damage. If the tool is damaged due to misuse or neglect by the customer, the warranty shall be null and void. For warranty
questions or issues please email [e-mail] or call US Toll-free 844-807-7887. To register your machine and receive a free blank folder in the
mail, email your name and address to [e-mail].

3.

Insert the folder in the opening of the
Diamond Press II tool. Use one hand to
hold the tool in place as your thumb
gently guides the folder into the machine.
Use your other hand to turn the handle.

• Do NOT put more than 1 sheet of
paper, or other material, through
the tool at one time.

• Do NOT force the handle. If it
becomes too dicult to turn, reverse
the handle and remove the folder. This
is an indication that you are trying to
cut or emboss something too thick.

• Do NOT cut anything thicker than
270 GSM, 0.011 in. or 0.28 mm.

Open the folder and remove your creation!

4.

• Dies will cause cut marks in blank
folders, this is a normal part of use. In
order to maximize the life of the folder,
rotate the side of the folder that
touches the cut-side of the die.

• When embossing a full strip of paper
there may be a wave in the paper after
it is embossed. This is normal, use your
hands to smooth it out.

TIP: The base of the Diamond
Press II tool is made of rubber
to help minimize movement
while using. Should it suction to
the table surface, pull up on the
rubber tab to release it.

Made in China

© 2019 Diamond Press
All Rights Reserved

www.mydiamondpress.com

If you have questions email

[e-mail]