Diamond HS-20 User Manual

Specialty Equipment Division

HS-20F Flush Cut

Hydraulic Hand Saw

PARTS BOOK

REVISED: 1-1-04

HAND SAW PARTS LIS

T

DRAWING #1

Part Number Description Qty. Required

2501494 LD Seal 1
2501628 Bearing 2
2501629 Race 2
2501630 Shaft Seal 1
2502545 FC Hub 1
2502546 Housing 1
2502559 20" FC Cover 1
2502563 Backing Ring 1
2502908 1/4" Water Way Tubing 2
2502909 1/4" Red Water Hose 1
2502910 Water Valve 1
2502912 Shear Pin 1
2502914 Clamp Water Tube 3
2502934 Washer 1
2502936 Female Elbow 1
2502938 Brass Nipple 1
2503508 24" FC Cover 1
2503511 24" FC Frame 1
2503512 20" FC Frame 1
2601642 15 GPM Motor 1
2601682 8 GPM Motor 1
2601683 12 GPM Motor 1
2702945 FC Shaft 1
2702947 Inner Collar Key 1
2703023 Grease Fitting 1
2900357 3/16-16x1 1/2" Bolt 1
2902961 Stover Half Nut 1
2902962 BS Nut LH Thread 1
2903013 5/16-18x5/8" FC Screws 6
2903040 Carriage Bolt 2
2903191 Nylock Nut 2
3200669 1/4" Hose Barb 1
3201276 Compression Fitting 2

HAND SAW PARTS LIS

T

DRAWING #2

Part Number Description Qty. Required

2502576 Straight Bushing 1
2502693 Quad Seal 2
2502897 Bearing 202 1
2502899 Flange Bushing 2
2502911 Valve Cap 1
2503333 Trigger 1
2702688 Metro Valve 1
2900991 1/4" Lock Washers 2
2900992 1/4" Flat Washers 2
2900997 1/4-20 X 1 1/2" Bolt 1
2900999 1/4-20 x 2" Bolt 2
2902986 5/16-18 Nut 1
2902988 5/16" Flat Washer 3
2903189 1/4-20 Nylock 1
2903190 5/16-18 Nylock 1
2903198 5/16-18 x 3 1/2" Bolt 1

HAND SAW PARTS LIS

T

DRAWING #3

Part Number Description Qty. Required

2502921 Fitting 1
2502924 Fitting 2
2503334 Tube Assembly 1
2503335 Tube Assembly 1
2702689 Fitting 1
3200764 Female QD 1
3200765 Male QD 1
3200802 Fitting 1
3200803 Fitting 1
3200805 Fitting 1
3201274 1/2" Swivel Fitting 2

EQUIPMENT AND PARTS

WARRANTY

Diamond Products warrants all equipment manufactured by it against defects
in workmanship or materials for a period of one (1) year from the date of
shipment to Customer.

The responsibility of Diamond Products under this Warranty is limited to
replacement or repair of defective parts at Diamond Products’ Elyria, Ohio
factory, or at a point designated by it, of such parts as shall appear to us upon
inspection at such parts, to have been defective in material or workmanship,
with expense for transportation and labor borne by Customer.

In no event shall Diamond Products be liable for consequential or
incidental damages arising out of the failure of any Product to operate properly.

Integral units such as engines, electric motors, batteries, transmissions,
etc., are excluded from this Warranty and are subject to the prime
manufacturer’s warranty.

THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESSED
OR IMPLIED, AND ALL SUCH OTHER WARRANTIES ARE HEREBY
DISCLAIMED.

333 Prospect Street, Elyria, Ohio 44035

[phone] • [phone] • Fax [phone]

www.diamondproducts.com

Printed in U.S.A.