DH Instruments CONNECTOR BLOC FOR RPM4, //m 401929 Installation Instructions Manual

//m CONNECTOR BLOC, P/N 402168, INCLUDES:
QTY PART NO DESCRIPTION
1 402169 //m connector bloc
2 101006-Z M3 screw
2 102464-Z M3 split washer
4 103345 Adapter, 1/8 in. M O-seal x 1/8 in. swage
1 560073 Instruction sheet
INTRODUCTION
The RPM4 //m connector bloc is an accessory for RPM4 parallel measurement mode operation. It supplies single TEST(+) and TEST(-) ports to assure a simple, leak free connection to both of the RPM4’s Q­RPTs in parallel.
The //m connector bloc can only be used with RPM4s that have two Q-RPTs of A7M or lower. Maximum working pressure is 7 MPa (1 000 psi).
INSTALLATION INSTRUCTIONS
Install the four 1/8 in. M O-seal x 1/8 in. swage
adapters on the RPM4 TEST(+) and TEST(-) ports (2). Remove the nuts and ferrules from each one of the adapters.
//m™
Connector Bloc for RPM4™
P/N 401929
Installation Instructions
Figure 1. //m connector bloc
Remove the two Philips head screws from the
extreme right and left hand corners of the RPM4 Hi and Lo Q-RPT modules (1, 3).
Remove the cover of the //m connector bloc by
removing the two top (5) and two lateral (4) button head socket screws.
Connect the four 1/8 swage F connections of the
//m connector (6) to the four 1/8 swage M adapters on the RPM4 TEST(+) and TEST(-) ports.
Attach the //m connector bloc (7) to the RPM4
using the two M3 screws supplied with the kit. Install the screws in the lower right hand corners of the Q-RPT modules (1, 3).
Leak check all connections and reinstall the //m
Figure 2. RPM4 rear panel Q-RPTs
(2 Q-RPTS of A7M or lower)
connector bloc cover.
RPM4 and //m are trademarks of DH Instruments, Inc.
Document 560073 041122
DH Instruments, Inc.
4765 East Beautiful Lane Phoenix AZ 85044-5318 USA
Tel 602.431.9100
Fax 602.431.9559 dhi@dhinstruments.com www.dhinstruments.com
Loading...